User manual JUNO JDA2420W

[. . . ] -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. -- The horizontal sections of the pipe must be slanted slightly downwards (about 10%) to ensure the condensed vapour not to come back on the motor of the hood. -- The best performance of the unit is obtained in the exhaust mode, therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. -- The best performances are obtained with short pipes (max. [. . . ] -- The best performances are obtained with short pipes (max. The air is purified by means of a carbon filter and then returned to the room. The active carbon filter can be ordered from the supplier. To install the filter, proceed as follow: fit the filter into its seat and fix with the two hooks C (fig. 1) can be fitted to the outlet hole using the screws supplied. Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. the hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. When installed, the hood must be not less than 42 cm. -- Fit the brown plastic front to the drawer with the same three screws O. The switching plate is fitted with two switches one for continuous adjustment of the ventilator (left switch) and one for illuminating the work surface (right switch). Before performing any maintenance operation, disconnect the hood from the electricity. Wash the filter, in a dishwasher or with detergent and water, periodically according to how often the appliance is used, but at least once every 4 weeks. When washed in a dishwasher, the metal grease filter may discolour. Before refitting the filter ensure that it is perfectly dry. To remove this filter push simultaneously the two handle Q towards the centre of the cooker hood then extract them (fig. Grill and metal filter are a unique indivisible component and they cannot be divided, to avoid any damage to it. This filter eliminates the odours and vapours which form during cooking. When used in normal conditions it should be replaced at intervals of 6-8 months. [. . . ] Grill and metal filter are a unique indivisible component and they cannot be divided, to avoid any damage to it. This filter eliminates the odours and vapours which form during cooking. When used in normal conditions it should be replaced at intervals of 6-8 months. These filter can be ordered from the supplier The carbon filter cannot be washed or regenerated. [. . . ]