User manual JUNO JDA5330W

[. . . ] We suggest to use Ø 120 mm exhausting pipe. underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. [. . . ] above gas or mixed-fuel burners. Warning! -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources otherthanelectricity, provisionmustbemade for an adequate supply of air. -- No food must be cooked flambé 7 Fixing the hood Apply the scheme supplied (Nº 49A) on the right of the cabinet so that the lines marked by the arrows match the cabinet ensuring that they meet at the back and under. Make two Ø 2 mm holes at points 1 and 2 (fig. Carry out the same operation on the left. Fix the hood to the cabinet using screws E (4, 5x16) supplied with the appliance (fig. Use the shim F supplied with the hood for 16 mm cupboard side panels. Fit the shim F to the left and to the right of the fixing curves of the hood and hook them in the holes. ventilator (left switch) and one for illuminating the work surface (right switch). Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. Metal grease filter Wash the filter, in a dishwasher or with detergent and water, periodically according to how often the appliance is used, but at least once every30 days. Before refitting the filter ensure that it is perfectly dry. Press the side handles (F) towards the opposite side and remove the filters. Remove the pull-out drawer completely and mount the grease filter so that it covers the drawer. Close the drawer and install the remaining grease filter. Adjusting the removable drawer The hood may be mounted in cabinets with different depths. [. . . ] Push the B knobs inwards toward each other (in the "Open" direction as indicated on the plastic knob itself). -- Always replace burnt-out lamps with olive shaped lamps max 40Watts-E14. [. . . ]