User manual JUNO JDI8940E

[. . . ] The grease filters are supplied not mounted and packed in order to avoid damages during transport of the hood. Fit the hooks of at the centre of the hood and push the handle upwards until the filter locks. Dismount the filter the opposite way (Fig. 1): pull the handle downwards and then at the side to loosen the filter. Use Two systems are available: -- External exhaust system -- Internal recycle system External exhaust system The air is vented outdoors by a 150 mm duct which must be connected to connecting ring with no return valve on top of the motor package. Internal recycle system The air is filtered through a carbon filter and recirculated into the room through the top sides of the chimney (Fig. [. . . ] Fix the deflector also on the other side of the structure with two other screws same shape. From the bottom of the telescopic supporting structure fit the connection ring supplied (bajonett attachment- turn clockwise and fix definitively with one screw 2, 9x9, 5). Fit a section of pipe or flex tube Ø 150 mm sufficiently long to reach the connection ring of the hood once this hood will be fit on place (Fig. Fix the supporting structure to the ceiling with 4 screws 5x45 and dowel (Fig. Sides with fixing points N for the external telescopic chimney correspond to the right and left sides (Fig. The hood is supplied with installation 14 fittings suitable for most kinds of ceilings, but in any case a qualified installation technician must be consulted in order to choose the best mounting solution. Fix the upper and lower part of the utter chimney together temporarily with one screw O 2, 9x6, 5 (Fig. Fix the upper part of the chimney to the supporting structure with two screws P 2, 9x6, 5 (Fig. Fit four auto locking nuts on the four pins located on the upper side of the hood (Fig. m. Fit temporarily the hood on the supporting structure by means of the already mentioned pins with nuts to be inserted on the proper holes located on the lower side of the supporting structure. Rotate the hood until it stops (Q - Fig. Secure the hood with one screw 4x9, 5 (S - Fig. Fit the electrical plug to the power outlet. Remove the screw that fix the two parts of the outer chimney together (Fig. Slide the lower part of the chimney downwards and insert it on its proper housing on the upper side of the hood (Fig. Fit the grease filters. Using the hood The hood has one variable speed motor. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. O 1 2 F 3 C CD G O I A A B E F C D G H I - B E F H I Motor OFF button ON button and motor speed selection button 1 - 2 - 3 - 1 - 2 - . Speed 1 LED Speed 2 LED and grease filter saturation LED (flashes) Speed 3 LED and carbon filter saturation LED (flashes) Intensive speed indicator LED Intensive speed ON switch OFF lamp button ON lamp button If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Intensive speed button This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. ). [. . . ] The metal filter should be washed when the grease filter saturation LED flashes or , anyway , almost once per month. Wash it with warm soapy water or, if possible, in the dishwasher (65°C). Let dry before reinstalling. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Never use products containing abrasive. Carbon filter This filter dissolves cooking odours. [. . . ]