User manual JUNO JDK9570E

[. . . ] This LED flashes to warn you that the metal grease filters must be cleaned. Generally, these must be cleaned after 40 hours of use. Once the grease filters have been cleaned, If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. [. . . ] To remove the metal grease filter - Fig. 2, F: To dismount the filter , push it backwards and then downwards. Carry out the above steps in reverse order to put the filters back after having washed them. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Wipe brushed stainless steel in the same direction as the brushing to avoid scratching. Attention Failure to observe the instructions for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Carbon filter ("recirculation mode only", see next pages) The carbon filter cannot be washed nor regenerated. Hood featuring control panel with keypad The carbon filter should be replaced every 6 months under normal use. Hood with electronic control panel The carbon filter should be replaced every 6 months under normal use and anyhow whenever the carbon filter saturation led indicates the saturation of the filter. This LED indicates carbon filter needs to be replaced. This led flashes to warn you that the carbon filter must be replaced. When frying foods, never leave the pan alone because the cooking oil could flare up. -- Please, keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. -- A constant maintenance guarantees a good 11 GB operation and good performance of the unit. -- The best performance of the unit is obtained in the exhaust mode, therefore in the limits of the possibilities it is advised to use the cooker hood in this way. -- The best performances are obtained with short pipes and with few curves. -- In order to eliminate loss of heat towards the outside; in the winter period the unit can be used in the recycling (filtering) mode. -- In the event of fire, disconnect immediately the unit from the power supply remove the source of fire (pots, etc. ). Systems available Two systems are available: Exhaust mode Vapours are extracted outside through an exhausting pipe that is affixed to the connection ring above the hood (Fig. Diameter of the exhausting pipe must be equal to that of the connection ring. [. . . ] Diameter of the exhausting pipe must be equal to that of the connection ring. In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. If the hood is supplied with carbon filter, then it must be removed. Installation - Fig. [. . . ]