User manual JUNO JDK9940S

[. . . ] Hood featuring control panel with keypad The grease filters must be washed at least once a month. Hood with electronic control panel ìThe metal grease filters must be washed at least once a month and anyhow whenever the metal grease filter saturation led (Speed 2 LED) indicates the saturation of the filter. [. . . ] The carbon filter saturation led C will now stop flashing. N. B. : the carbon filter saturation led will also flash even if the hood is used in the exhausting version (i. e. To stop the led flashing, press the two buttons A and B as described above. Fit the carbon filter into its housing, by pushing it backwards and then forwards and fixing it with the two red buttons B on the carbon filter. Put the metal grease filter back into place. 3: To dismount the carbon filter, press the two buttons B and pull downwards . Replacing the lamp - Fig. 6, M Unplug the appliance from the mains Remove the burnt lamp. Fit the new lamp ensuring that the two male contacts of the lamp fit perfectly into the female contacts of the lamp holder. -- If the lighting is not operating, remember to check that the lamps are fitted correctly before calling your technician. -- -- -- -- Warning! -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. -- No food must be cooked flambé underneath the hood. [. . . ] above gas or mixed-fuel burners. Recirculation mode (K - See the installation diagram) The air is filtered through a carbon filter and recirculated into the room through the grid on the higher part of the chimney. If the hood is not supplied with carbon filter, then it must be ordered and mounted. Electric connection Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood It is advisable to call a qualified technician to make the electrical connection. Fastening of shelves (optional) Fasten the four side supports I to the adjacent cabinets and place the shelf on the supports (Fig. [. . . ]