User manual JUNO JDL4530B

[. . . ] -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. -- No food must be cooked flambé underneath the hood. [. . . ] Some carbon filters are supplied wrapped in a plastic film, this to protect their filtering properties, remove this plastic film before fitting the carbon filter. -- The horizontal sections of the pipe must be slanted slightly downwards (about 10%) to ensure the condensed vapour not to come back on the motor of the hood. -- The best performance of the unit is obtained in the exhaust mode, therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. -- The best performances are obtained with short pipes (max. The switching plate is fitted with two switches one for continuous adjustment of the ventilator (right switch) and one for illuminating the work surface (left switch) . Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. the hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. Before performing any maintenance operation, disconnect the hood from the electricity. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. The grease filters must be washed at least once a month. When washed in a dishwasher, the metal grease filter may discolour. Before refitting the filter ensure that it is perfectly dry. After having adjusted the hood for the version required, it may be installed. -- This appliance is designed for fitting in a cabinet or some other support. [. . . ] We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. [. . . ]