User manual JUNO JDM2940E

[. . . ] Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. the hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. [. . . ] -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. A) Place the top edge of the template at the centre of the lower edge of the cabinet and mark off four holes on the wall. 2) c) From below, fit the upper casing of the hood in the cabinet opening flush to the wall until it stops and fasten it to the wall with two 5 x 45 mm screws in the upper plugs previously inserted in the wall (Fig. 5 x 13 mm wood screws from inside the upper casing of the hood in the lower edge of the cabinet. D) With 4 guide pins insert the lower exhaust part to the upper part and fasten with the two clamps positioned one to the right and one to the left. Finally, fasten the lower part of the hood securely to the upper using the five 4 x 8 mm sheet metal screws provided. Insert two 5 x 45 mm screws from inside the lower part of the hood in the two 8-mm diameter plugs and fasten the hood to the wall (Fig. E) Loosen the fastening screws of trim M so that it slides to the desired height; then retighten the two screws (Fig. G) If the hood has to be disassembled (for example for technical assistance) reverse the above procedure. The Led marked F flashes to warn you when the grease filter needs to be cleaned. If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Once the grease filters have been cleaned or the charcoal filter replaced, press the A button for approximately 3 seconds until you hear the (beep): Now fix it into place using the two hooks G of the carbon filter. It is not necessary to replace the two screws. 3: -- To dismount, press the two buttons A and pull gently forwards to remove the filter from its housing. Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Before performing any maintenance operation, disconnect the hood from the electricity. 2) inwards so that they rotate longitudinally 45° and then pull the two handles towards the centre of the appliance at the same time. [. . . ] 2) inwards so that they rotate longitudinally 45° and then pull the two handles towards the centre of the appliance at the same time. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. The grease filters must be washed at least once a month. When washed in a dishwasher, the metal grease filter may discolour. [. . . ]