User manual JUNO JDS1320B

[. . . ] In the case of the internal recycle version proceed as follows: a) Request an active carbon filter suitable for this model from your supplier. B) Remove the grill E turning the locks D and pull it out downwards (fig. C) To install the filter, fit it in the seat first upper then lower with the two hooks G (fig. When installed, the hood must be not less than 65 cm. [. . . ] When installed, the hood must be not less than 65 cm. -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. -- No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. -- Please , keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. --The air is purified through an active carbon filter and returned to the room. To get best efficiency, we suggest to use slow speeds in normal conditions and the highest in particular cases of strong smell and vapour concentration. The metal grease filter lasts forever and must be washed at least once a month either by hand or in the dishwasher (60°C) with suitable detergents. When washed in a dishwasher, the metal grease filter may discolour. Let the filter dry without damaging it before putting it back into place. Every time you clean the metal grease filter also clean the grid with suitable detergents without abrasive. The switching plate is fitted with two switches one for continuous adjustment of the ventilator (top switch) and one for illuminating the work surface (bottom switch) . Note: Simply close the front panel to switch off the hood (light and motor). When you pull up the front panel, the hood (light and extraction motor) switches on again as previously set. It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. The hood doesn't switch-ON if the flap is not mounted. [. . . ] It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. The hood doesn't switch-ON if the flap is not mounted. Change the filter at least once every 4 months. To remove the carbon filter push the pushbuttons G inwards and pull the filter downwards (fig. [. . . ]