User manual JUNO JDS1320W

[. . . ] -- Please , keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. In this case the fumes are conveyed outside by means of a special pipe connected with the coupling flange A, placed in the hole B (Fig. We suggest to use Ø 120 mm exhausting pipe. [. . . ] According to your installation the pipe can be directed either towards the ceiling or towards the walls (Fig. -- The air is purified through an active carbon filter and returned to the room. -- The use of an active carbon filter is necessary when an exhaust pipe to the exterior is not available, or when it is not possible to install this type of pipe. in the case of the internal recycle version proceed as follows: a. Request an active carbon filter suitable for this model from your supplier. Remove the inlet grid E turning the locks D and pull it out downwards (Fig. Then turn it in the clockwise direction until the filter is locked in place. -- The horizontal sections of the pipe must be slanted slightly upwards (about 10%) to ensure an easy flow of the air outwards. -- The best performance of the unit is obtained in the external exhaust model (suction), therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. -- The best performances are obtained with short pipes (max. When washed in a dishwasher, the metal grease filter may discolour. Let the filter dry without damaging it before putting it back into place. Every time you clean the metal grease filter also clean the grid with suitable detergents without abrasive. This hood can be equipped with a circular charcoal filter. the charcoal filter cannot be regenerated or washed. The charcoal filter must be replaced every 4 months. To remove the charcoal filter, turn it in the counter clockwise direction unitl it comes free. The switching plate is fitted with two switches one for continuous adjustment of the ventilator (top switch) and one for illuminating the work surface (bottom switch) . Note: Simply close the front panel to switch off the hood (light and motor). When you pull up the front panel, the hood (light and extraction motor) switches on again as previously set. [. . . ] Note: Simply close the front panel to switch off the hood (light and motor). When you pull up the front panel, the hood (light and extraction motor) switches on again as previously set. It is advisable to switch on the extractor hood a few minutes before starting cooking and then to leave it running for approximately 15 minutes afterwards to ensure that all odours are extracted. The hood doesn't switch-ON if the flap is not mounted. [. . . ]