User manual JUNO JDS2720B

[. . . ] d) Re-insert the inlet grill e) The deflector (fig. The deflector conveys the air frontwards avoiding to dirty the rear wall. Using the hood The hood can be used as follows: Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. -- The hood must not be connected to fuel exhaust flues (boilers, heating systems, water heaters, etc. ). [. . . ] -- Please, keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. Fixing the hood Mounting the hood on the wall Make use of the scheme N1 provided, applying it on the wall. Place the hooks L provided with screws and blocks in the upper holes. Place the expansion plugs M supplied with the hood in the lower holes (fig. Fix the angle frame N (using either the long or the short arm, depending on the depth of the side cupboards) to the wall at the right height. Adjust the position of the upper brackets O, fix the hood to the hooks L, check that the hood is at the right height (to eventually adjust the height work on the screws P, fig. Fix the hood to the lower angle frame by means of the screws Q. For a further adjustment act on the screws R through the holes S (fig. 11). External exhausting version In this case the fumes are conveyed outside by means of a special pipe connected with the coupling flange A, placed in the hole B (fig. Choosing the exhausting pipe The coupling ring B has a diameter of 120mm. We suggest to use Ø 120 mm exhausting pipe. Drill two holes 2, 5 mm diameter in the points C1 and C2 (fig. Fix the hood to the cupboards by means of the screws T (fig. 14). 14 15 Replace the door, inserting it first in the upper then in the lower slides, turn the rear locking knobs and then mount the grill, following in reverse, the operations described under paragraph "Internal Recycle version". Adjust the angle frame tightly to the wall, making use of the apposite screws Q (fig. 11). Instructions of use Hood model JDS 5320 is fitted with one motor. The power is adjusted by means of a 3-speed switch. To get best efficiency, we suggest to use slow speeds in normal conditions and the highest in particular cases of strong smell and vapour concentration. Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. This appliance meets 87/308 EWG radio and television noise standards. Grease filter The hood has a metal grease filter. To clean the filter, proceed as follows: -- Open the grill by turning locks D (fig. -- Extract the filter V after removing the clamps U (fig. -- With normal use, the grease filter should be washed once a month in a dishwasher or in warm soapy water and should be left to dry before being refitted. [. . . ] -- Extract the filter V after removing the clamps U (fig. -- With normal use, the grease filter should be washed once a month in a dishwasher or in warm soapy water and should be left to dry before being refitted. When cleaning the grease filter, we recommend washing the grill too with warm water and soap. A thin synthetic filter may be used as an alternative to the metal filter. [. . . ]