User manual JUNO JDS3230B

[. . . ] -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. -- The horizontal sections of the pipe must be slanted slightly upwards (about 10%) to ensure an easy flow of the air outwards. -- The best performance of the unit is obtained in the exhausting version, therefore in the limits of the possibilities it is advised to use the hood in this version. -- The best performances are obtained with short pipes (max. [. . . ] The air is filtered through a carbon filter (to install them see paragraph - Carbon filter -) and recirculated into the room through the grating on the upper chimney part. If the hood is not supplied with carbon filter, then it must be ordered and mounted. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. the hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. When installed, the hood must be not less than 65 cm. -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. Upon installation, the saturation control device for the carbon filter is not activated (the hood is ready for use in vent mode). Once the grease filters have been cleaned or the carbon filter replaced, press the A button for approximately 3 seconds until you hear the (beep): Before performing any maintenance operation, disconnect the hood from the electricity. At the start of this procedure, only the F Led will blink, after 3 seconds have passed, the C Led will begin to blink, as well to indicate that the saturation control device for the carbon filter has been activated. Remove the metal filter using the handles designed for this purpose by pulling them backwards and then downwards. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. The grease filters must be washed at least once a month. Before refitting the filter ensure that it is perfectly dry. The metal grease filter might discolours when washed in the dishwasher. The Led marked F flashes to warn you when the grease filter needs to be cleaned. It should be changed every 4 months in normal use. [. . . ] It should be changed every 4 months in normal use. fitting the carbon filter Fit the carbon filter into its housing, by pushing it backwards and then forwards and fixing it with the two red buttons B on the carbon filter. Dismounting the carbon filter To dismount the filter, press the two buttons B and pull it downwards. B) Remove the blown halogen light bulb using a screwdriver. [. . . ]