User manual JUNO JDS5320B

[. . . ] --The use of an active carbon filter is necessary when an exhaust pipe to the exterior is not available, or when it is not possible to install this type of pipe. In the case of the internal recycle version proceed as follows: a) Request an active carbon filter suitable for this model from your supplier. b) Remove the grill E turning the locks D and pull it out downwards (fig. [. . . ] Ø 120 mm exhausting pipe: the multiconnector has not to be fitted. Ø 125 mm exhausting pipe: insert the multi-connector on the coupling ring and remove, using a proper tool, the upper unused Ø 100 and Ø 110 mm rings of the multi-connector. Ø 110 mm exhausting pipe: same procedure, but removing the Ø 100 mm ring only. Ø 100 mm exhausting pipe: apply the multi-connector on the coupling ring. Suggestions for the installation and use of the hood -- The horizontal sections of the pipe must be slanted slightly upwards (about 10%) to ensure an easy flow of the air outwards. -- The best performance of the unit is obtained in the external exhaust model (suction), therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. -- The best performances are obtained with short pipes (max. 4 m) and with few curves. Installation The hood must be installed at least 65 cm from the hob of electric cookers and at least 75 cm from the hob in the case of gas or mixed cookers. Fixing the front panel Take off the door H (fig. Apply the scheme N3 on the rear side of the front panel, considering that the arrow indicates the upper side (fig. 7), drill where indicated by the scheme. Then fix the door to the front panel by means of the screws N (fig. 8). Warning! -- If the hood is run at the same time as a burner or fireplace that depend on ambient air (for example gas, Diesel, coal or wood heaters, water heaters, etc. ) be careful, because the hood, when it exhausts the air, removes the ambient air required by the burner or fireplace for combustion. -- For secure operation and to prevent discharged gas from coming back in, the vacuum must not exceed 0, 04 mbr. This may be done by making sure the air inlet into the room passes through nonclosing openings such as air recycling wall boxes, doors, windows or with other technical measures. -- No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. Electric connection Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. The hood is supplied with a standard plug; connect it to a correspondingly standard socket. [. . . ] Change the filter at least once every 6-8 months. To remove the carbon filter push the pushbuttons G inwards and pull the filter downwards (fig. 4). Important The switching plate is fitted with two switches one for continuous adjustment of the ventilator (top switch) and one for illuminating the work surface (bottom switch) . [. . . ]