User manual JUNO JDS5320W

[. . . ] When frying foods, never leave the pan alone because the cooking oil could flare up. -- Please, keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. Suggestions for the installation and use of the hood -- The horizontal sections of the pipe must be slanted slightly upwards (about 10%) to ensure an easy flow of the air outwards. [. . . ] -- The best performances are obtained with short pipes (max. 4 m) and with few curves. Recycling version The air is filtered through two carbon filters (to install them see paragraph - Carbon filter -) and recirculated into the room through the grating on the lower chimney part. If the hood is not supplied with carbon filter, then it must be ordered and mounted. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. Electric connection Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. The hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. 7 Installation When installed, the hood must be not less than 65 cm. above gas or mixed-fuel burners. Warning! -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. The grease filters must be washed at least once a month. Before refitting the filter ensure that it is perfectly dry. Position of filters is interchangeable. Carbon filter (2 pieces) This filter dissolves cooking odours. It should be changed every 4 months in normal use. Mounting and replacing the carbon filter: a) Disconnect the hood from the electricity. c) If the filters have not been installed, place one filter on each side so that they cover the grates protecting the rotor on the motor. Then turn the center handle for the filters in the clockwise direction (Fig. d) If the charcoal filters have already been installed (covering the grates protecting the rotor on the motor) and must be replaced, turn the central handle in the counter-clockwise direction until the filters are unlocked. [. . . ] d) If the charcoal filters have already been installed (covering the grates protecting the rotor on the motor) and must be replaced, turn the central handle in the counter-clockwise direction until the filters are unlocked. 8 e) Refit the exhaust grate or the grease filter. Replacing the lamp a) Disconnect the hood from the electricity. c) Always replace burnt-out lamps with 40Watt max. [. . . ]