User manual JUNO JGI4423

[. . . ] ¥ Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Care should be taken when moving it Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. [. . . ] The materials used on this appliance marked by the symbol are recyclable. ¥ CONTENTS Warnings . . 11 Use - Cleaning the interior - Control Panel - Operation - Temperature regulation - Quick-freezing - Warning . . 13 Use - Freezing fresh food - Storage of frozen food - - Thawing - Ice-cube production - Cold accumulator . . 14 Use - Hints for storage of frozen food - Maintenance - Periods of no operation - Periodic cleaning . . 15 Customer service and spare parts - Installation - Location - Electrical connection - Door reversibility . . 16 12 USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Contol Panel 6 5 4 3 2 1 A A. G. B C DE F Quick-freezing G Pushbutton for the interruption of the sound signal Thermostat knob Normal/Super switch Super control light Pilot light Warning light Pushbutton for the interruption of the sound signal For quick-freezing, slide the knob (C) towards the left. The quick-freezing light (D) will then light up. Warning light (F) The temperature alarm light turns on automatically whenever the temperature within the freezer rises above a certain value which might endanger satisfactory long-term conservation. It is perfectly normal for the temperature alarm light to remain lit up for a short time after the freezer is initially turned on. It will remain lit up until the optimum temperature for the conservation of frozen food is attained. Operation Insert the plug into the wall socket. The pilot light (E)will light up, indicating that the appliance is powered. Turn the thermostat knob (B), clockwise, beyond the ÇOÈ (STOP) position. To stop operation, simply turn the thermostat knob to position ÇOÈ. Sound signal alarm (A) This appliance incorporates an alarm which gives off a sound signal when the temperatureinside the freezer has risento a point where the safe storage of frozen food is no longer ensured. This alarm will come on when the appliance is just being started or when the food has just been put in the freezer. This sound can be turned off be depressing pushbutton (A). Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: ¥ room temperature; ¥ how often the door is opened; ¥ the quantity of food stored; ¥ location of appliance. A medium setting is generally the most suitable. Sound signal alarm (G) This appliance incorporates an alarm which gives off a sound signal when the door remains open for more than 30 seconds. The signal can be stopped by closing the door or by depressing the pushbutton (G). 13 Freezing fresh food The 4-star compartment is suitable for long term storage of commercially frozen food and for freezing fresh food. To freeze fresh foods allow it to run on the fast freeze setting for at least 24 hours before loading food. Place the food to be frozen in the compartments as shown in figure. [. . . ] Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D C D727 Apply the sealing strip pushing it between the refrigerator and the adjacent cabinet. D724 If after having carried out the previously described operation there is still some space between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). A D265 17 Apply covers (B) on joint cover lugs and into hinge holes. B D726 Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. A 20m m PR33 Open both the appliance door and that of the kitchen unit to approx. [. . . ]