User manual JUNO JKG1454

[. . . ] JKG 1454 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS MODE D'EMPLOI GEBRUIKSAANWIJZING 2222 144-05 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 13 14 14 14 14 15 16 18 18 18 18 18 18 19 19 19 20 21 21 21 21 Installation . . Starting-up and Temperature Regulation . . Ice-cube production . Fresh food refrigeration . [. . . ] Remove the middle hinge and refit it on the opposite side. Refit the door and pin (A) on the left side. Remove pin (D) from the right side. Housing's dimensions Height Depth Width 1225 mm 550 mm 560 mm 15 Instructions for total built-in 50-min. 2 For appropriate venting, follow indications in Fig. 2. Press in the joint covers between the appliance and the kitchen furniture. min. 3 A Push appliance into housing until stop strip (A) touches the kitchen unit. B Apply covers (B) on joint cover lugs and into hinge holes. D353 D023 Fig. 4 A D265 If after having carried out the operation described in the previous section there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 5 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the posi20m tion of the external m holes. After preparing the h o l e s , s c re w t h e D094 runners to the kitchen unit door using 3. 5x16 mm screws. H Fig. 9 8mm Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance D with 4 screws provided in the kit included with the apC pliance. Snap vent grill (C) and hinge cover (D) into position. Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. PR34 16 Fig. 10 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit PR35 door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. 17 OPERATION Starting-up and Temperature Regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the upper right side of the inner liner clockwise, beyond the «O» position, to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. [. . . ] Use the special cleaner provided, which you will find already inserted into the discharge hole (Fig. 14 The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. [. . . ]