User manual JUNO JKG6493

[. . . ] JKG 6493 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS MODE D'EMPLOI GEBRUIKSAANWIJZING 2222 001-81/1 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 14 15 15 15 15 16 17 19 19 19 19 19 19 19 20 20 20 21 21 21 21 22 22 23 23 23 23 23 Installation . Positioning . Electrical connection . . Control panel Use of the freezer . [. . . ] 1 Right opening Remove the pins (P) and (P1). Left opening Remove (P) from both sides and the door. Remove (A) from the left side and (B-C-D) from the right side. Refit (B-C-D) on the left side and (A) on the right side. Refit the door and (P) on the left side. Remove (P1) from the right side. 16 Building-in instructions Housing dimensions Height Depth Width 1780 mm 550 mm 560 mm Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 5 For safety reasons, minimum ventilation must be as shown in Fig. 2: Attention: keep ventilation openings clear of obstruction. 50 mm min. cm 200 2 C Press in the joint covers between the appliance and the kitchen furniture. D369 Fig. 6 D526 Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D098 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 D023 If after having carried out the operation described in section 3 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 B A D096 D265 17 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 In case of side fixing of the appliance, it will be sufficient to loose the screws fixing the bracket (G) and to position it as shown in Fig. 11 H G 20m m D397 G D094 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 8mm PR34 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). [. . . ] Further hints for getting the best out of your refrigerator are as follows: Cooked foods, cold dishes, jellies, etc. , should be well covered; Fruit and vegetables should be washed before being stored; Raw meat (of all types, including poultry) should be stored in plastic bags. D351 21 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motorcompressor stops. The defrost water drains out through a trough (Fig. 15) into a special container provided on top of the compressor which is located at the back of the appliance. Fig. 15 Turn the knob (A) back to the desired position or replace the plug in the socket. [. . . ]