User manual JUNO JKG7461

[. . . ] Should the lining up of the furniture door be necessary, use the clearance of slots. Fix cover (D) on guide (B) until it clips into place. If the appliance is fixed to the side of the kitchen unit, simply slacken the screws in the fixing brackets (D), move the brackets as shown in the figure and retighten the screws. Apply covers (B) on joint cover lugs and into hinge holes. [. . . ] To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance, on the bottom left-hand side. The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. To obtain the best performance from this appliance, you should: · Make sure that the commercially frozen foodstuffs were adequately stored by the retailer; be sure that frozen foodstuffs are transferred from the foodstore to the freezer in the shortest possible time; Not open the door frequently or leave it open longer than absolutely necessary. Once defrosted, food deteriorates rapidly and cannot be refrozen. Do not exceed the storage period indicated by the food manufacturer. Unplug the appliance before carrying out any maintenance operation. When the appliance is not in use for long periods, take the following precautions: remove the plug from the wall socket; remove all food; defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells. Clean the inside with warm water and bicarbonate of soda. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operstion will improve the performance of the appliance and save electricity consumption. The 4-star compartment is suitable for long term storage of commercially frozen food and for freezing fresh food. To freeze fresh foods it is not necessary to move the thermostat knob from the normal setting. However, for a faster freezing operation, turn the termostat knob to the coldest setting; but remember that, in this condition, the refrigerator compartment temperature might drop below 0°C. if this oocurs reset the thermostat knob to a warmer setting. Place the food to be frozen in the upper in the freezer compartment as this is the coldest part. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run for at least two hours on the coldest setting, then turn the thermostat knob to the normal operating position. Important If there is a power failure when food is in the freezer, do not open the door of the freezer compartment. The frozen food will not be affected if the power cut is of short duration (up to 6-8 hours) and the freezer compartment is full, otherwise, it is recommended that the food should be used within a short time (a temperature increase of the frozen food shortens its safe storage period). The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: · Room temperature; how often the door is opened; the quantity of food stored; location of appliance. [. . . ] Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. if the appliance has been transported horizontally , it is possible that the oil contained in the compressor ílows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow tlie oil to flow back in the compressor. [. . . ]