User manual JUNO JKG7471

[. . . ] JKG 7471 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS MODE D'EMPLOI GEBRUIKSAANWIJZING 2222 147-05/1 CONTENTS Warnings . page 12 13 13 13 13 13 16 16 16 17 17 17 17 18 19 19 19 Installation . Positioning . Electrical connection . Cleaning the interior . Instructions for totally built-in appliances . [. . . ] Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. D023 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 13 If after having carried out the operation described in section 2 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 3 Press in the joint covers between the appliance and the kitchen furniture. Fig. 5 A D098 D265 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 6 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 4 B D339 D D388 C Position the runners (H) inside the kitchen unit door as shown in Fig. 7 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 7 H 20m m D094 14 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 8 If the appliance is to be fitted laterally to the kitchen unit, it will be sufficient to loosen the screws of the little plates (F), move them as shown in Fig. 9a 8mm F G D398 D415 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). If the kitchen unit door needs to be re-aligned, adjust the position of the screws in the slots. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 9 D416 15 OPERATION Refrigerator/Freezer - Starting-up and Temperature Regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the upper right side of the inner liner, clockwise, beyond the «O» position, to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. A medium setting is generally the most suitable. [. . . ] 12) into a special container on the back of the appliance where it evaporates. Fig. 12 When defrosting is completed, dry the interior thoroughly; Keep the scraper for future use, replace the plug in the socket and, after letting the appliance run for at least half an hour, replace the previously removed food into the compartment. Important A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. D037 The freezer compartment, however, will become progressively covered with frost. [. . . ]