User manual JUNO JKG7484

[. . . ] JKG 7494 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS MODE D'EMPLOI GEBRUIKSAANWIJZING 2222 215-31 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 14 15 15 15 15 16 17 19 19 19 19 19 19 19 20 20 20 21 21 22 22 23 23 23 23 23 Installation . Positioning . Electrical connection . . Control panel Use of the freezer . [. . . ] The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. ; best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. For building into kitchen units follow the special "Building-in" instructions given. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 15 Door reversibility (Fig. 1) P P A D B C D C P1 D337 P1 Fig. 1 Right opening Remove the pins (P) and (P1). Left opening Remove (P) from both sides and the door. Remove (A) from the left side and (B-C-D) from the right side. Refit (B-C-D) on the left side and (A) on the right side. Refit the door and (P) on the left side. Remove (P1) from the right side. 16 Building-in instructions Housing dimensions Height Depth Width 1780 mm 550 mm 560 mm Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 5 For safety reasons, minimum ventilation must be as shown in Fig. 2: Attention: keep ventilation openings clear of obstruction. 50 mm min. cm 200 2 C Press in the joint covers between the appliance and the kitchen furniture. D369 Fig. 6 D526 Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A D098 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 D023 If after having carried out the operation described in section 3 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 B A D096 D265 17 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. [. . . ] For better use of space, the front half-shelves can lie over the rear ones. Fig. 14 PR190 21 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motorcompressor stops. The defrost water drains out through a trough (Fig. 16) into a special container provided on top of the compressor which is located at the back of the appliance. Fig. [. . . ]