User manual JUNO JKI 1433

[. . . ] Children should not be allowed to tamper with the controls or play with the appliance. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this appliance in any way. [. . . ] The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. D022 PR31 Fig. 2 A Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. A Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. D265 If after having carried out the operation described in section 2 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). 11 Fig. 8 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. D Fasten the appliance with 4 screws provided in the kit inC cluded with the apD727 pliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 5 8mm PR34 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 Press in the joint covers between the appliance and the kitchen furniture. D724 Fig. 6 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, PR35 if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Apply covers (B) on joint cover lugs and into hinge holes. Inner door reversal (Fig. Remove the inner door, taking care that pin (4) does not fall. Remove bush (5) and fit it into the opposite corner of the door. Remove catch (3) by undoing the screw and refit it on the opposite side. Move pin (4) to the hole in the opposite side of the door. Position the door pressing pin (1) into place. Fig. [. . . ] The rating is shown on the light bulb cover. Fig. 12 Periodic cleaning Clean the inside with warm water and bicarbonate of soda. Rinse and dry thoroughly. Periods of non-use When the appliance is not in use for long periods, take the following precautions: remove the plug from the wall socket; remove all food; defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells. D206 SERVICING If a fault occurs, check the following before calling the Servicing Department: The light does not come on when you open the door. If the electricity supply is OK, replace the bulb. [. . . ]