User manual JUNO JKI1031

[. . . ] Refer to your local Service Centre, and always insist on genuine spare parts. s s s Use s s s s The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Frozen food must not be re-frozen once it has been thawed out. Manufacturers' storage recommendations should be strictly adhered to. The inner lining of the appliance consists of channels through which the refrigerant passes. [. . . ] Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided. Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Starting-up Insert the plug into the wall socket. Open the door and turn the thermostat control knob, to be found on the upper right hand side of the inner compartment, clockwise beyond position «O» (OFF) to start the appliance. Temperature control Temperature adjustment is obtained by turning the thermostat knob clockwise until its pointer coincides with the required setting. A medium setting is generally the most suitable. The minimum setting (least cold) is represented by the lowest number and the maximum setting (coldest) by the highest number. In any case, bear in mind that the temperature can be either increased (warmer) by turning the thermostat knob anticlockwise or decreased (colder) by turning it clockwise. The thermostat knob setting should be adjusted depending on the inner temperature of the refrigerator, which, in turn, depends on a number of factors, such as: the ambient temperature, the number of times the door is opened, the quantity of food stored and the location of the appliance. Warning If the ambient temperature is high, the thermostat knob is on the coldest setting (higher numbers) and the appliance is fully loaded, the compressor may run continuously, causing frost or ice to form on the evaporator. If this happens, turn the knob to a warmer setting (lowernumbers) to allow automatic defrosting and so a saving in electricity consumption. Inner arrangement Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D040 17 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: 1. pull out the plug from the wall socket or turn the thermostat knob to the «O» setting; 2. remove any stored food, wrap it in several layers of newspaper and put it in a cool place; 3. leave the door open, place a basin on the top shelf of the refrigerator compartment, under the drain hole, remove the plug as shown in the figure; 4. when defrosting is completed, dry the interior thoroughly and refit the plug. Keep the scraper for future use; turn the thermostat knob back to the required setting or replace the plug in the power socket. After two or three hours, reload the previously removed food into the compartment. Important A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. D037 PR151 19 Maintenance Unplug the appliance before carrying out any maintenance operation. Interior light The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not go on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. [. . . ] Snap vent grille (C) and hinge cover (D) into position. 22 5. Press in the joint covers between the appliance and the kitchen furniture. 6. Apply covers (B) on joint cover lugs and into hinge holes. 7. Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. [. . . ]