User manual JUNO JKI4053

[. . . ] ¥ Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Care should be taken when moving it ce lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. [. . . ] Attention: keep ventilation openings clear of obstruction. ¥ If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. ¥ CONTENTS Warnings . . 13 Use - Cleaning the interior - Operation - Temperature regulation - Fresh food refrigeration - Freezing fresh food - Storage of frozen food - Thawing - Ice-cube production . . 15 Use - Movable shelves - Bottle holder - Positioning the door shelves - Hints - Hints for refrigeration . . 16 Hints - Hints for freezing - Hints for storage of frozen food - Maintenance - Periods of no operation . Maintenance - Periodic cleaning - Interior light . . 17 Maintenance - Defrosting - Customer service and spare parts . . 18 Installation - Location - Door reversibility - Electrical connection - Building-in instructions . . 19 Installation - Inner door reversal . . 21 USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the ÇOÈ (STOP) position. To stop operation, simply turn the thermostat knob to position ÇOÈ 11 Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: ¥ ¥ ¥ ¥ room temperature; how often the door is opened; the quantity of food stored; location of appliance. Fresh food refrigeration To obtain the best performance: ¥ ¥ ¥ do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it. A medium setting is generally the most suitable. [. . . ] Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D C D727 Apply the sealing strip pushing it between the refrigerator and the adjacent cabinet. D724 If after having carried out the previously described operation there is still some space between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). A D265 15 Apply covers (B) on joint cover lugs and into hinge holes. B D726 Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. A 20m m PR33 Open both the appliance door and that of the kitchen unit to approx. [. . . ]