User manual JUNO JKI4331

[. . . ] Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this appliance in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. [. . . ] directive number 87/308 of 2. 6. 87 relative to radio interference suppression. Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. ; best performance is obtained with ambient temperature between +16°C and +32°C. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the inside Before using, clean all inside parts with warm water and neutral soap to remove the typical new smell. Do not use abrasive detergent or powders as these can damage the finish. 12 Building-in instructions Dimensions of the recess Height of housing mm 880 Depth of housing mm 550 Width of housing mm 560 The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For appropriate venting, follow indications in Fig. cm2 200 If after having carried out the operation described in section 2 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. cm 2 200 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 4 D028 Push appliance into the housing until stop strip (A) touches the kitchen unit. Fig. 2 A D C D130 Press in the joint covers between the appliance and the kitchen furniture. Fig. 5 D022 D128 13 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 6 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 9 B D013 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 7 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. Remove the inner door, taking care that pin (4) does not fall. Remove bush (5) and fit it into the opposite corner of the door. Remove catch (3) by undoing the screw and refit it on the opposite side. [. . . ] Do not use metal tools to remove the frost ­ they can cause serious damage. It is not necessary to switch the appliance off or take the food out of the compartment during this operation. If a thick layer of ice forms, the appliance must be completely defrosted. If the electricity supply is OK, replace the bulb. [. . . ]