User manual JUNO JSI4360W

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. s s Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. RC01 A After loading your machine always close the door, as an open door can be a hazard. 35 PBA16GB Hints and tips To save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme (see Programme Chart on the following pages), so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme. Do not prewash dishes under running water. glasses and crockery (except pots) so that you may re-use them promptly. ** This is a special programme for quick washing (approx. 52 minutes) a full load of lightly soiled dishes, 37 PWP18GB ENGLISH Normal * 65° Normal soil. Crockery, cutlery pots and pans 65° Normal On Off 25 g 5g Operating sequence 1. Check the filters Ensure they are clean and properly positioned (see cleaning instructions). ENGLISH 9. Start the programme Depress the On/Off button. The On/Off indicator light will come on and the machine will start. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). ENGLISH Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water; 2. Leave the door ajar to prevent the formation of any unpleasant smells; 4. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge; 4. Pull the machine out together with the hoses. Avoid over tilting the machine during transport. 40 PMC02GB Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed below. Symptom The machine will not start Solution s s s s The door has not been properly closed. The plug is not properly inserted in the power socket. Ensure the mains water supply has not been cut off. [. . . ] It is essential that the recess dimensions indicated in the diagram are followed. ENGLISH No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. The recess height may be anywhere between 820 and 880 mm from the floor since the dishwasher incorporates adjustable feet (max 60 mm). A distance of 2 mm should be allowed between the top of the dishwasher and the counter top. Adjusting the height of the appliance To adjust the height proceed as follows: 1. The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right. [. . . ]