User manual JUNO JSI5462W

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. s s Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. This product should be serviced by an authorised Service engineer, and only genuine spare parts should be used. [. . . ] Before closing the door, ensure that the spray arms can rotate freely. US41 IEC 436 / DIN 44990 Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. Never lift or lower the basket on one side only. To move to the higher position proceed as follows: 1. Certain types of glass can also become opaque after being washed several times in a dishwasher. A chemical reaction can occur between silver cutlery and stainless steel cutlery. Iron and cast iron objects can rust and stain other items. Aluminium tends to go black, copper, pewter and brass tend to stain. If in doubt check with manufacturer of the item. When buying new dishes, ensure that they are dishwasher proof. 36 PHT04GB Washing programmes Programme Degree of soil and type of load Starting position of the programmer Required pushbuttons Recommended quantity of detergent on the in the dispenser dispenser lid Cycle description Hot prewash Main wash up to 70°C 2 cold rinses 1 hot rinse up to 65°C Drying phase Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse up to 65°C Drying phase Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse up to 65°C Drying phase Main wash up to 50°C 1 cold rinse 1 hot rinse up to 55°C 70° IntensivProgramm (Intensive 70°C) * 65°NormalProgramm Normal soil. Crockery, cutlery pots and pans Normal soil. Partial load (to be completed later in the day). 65° Normal On Off 25 g 5g Programm (Economy 50°C) * 50° Eko- 50° Eko 50° On Off On Off On Off 25 g 5g ** 50° QuickProgramm VorspülProgramm (Rinse and Hold) 50° Quick 50° 25 g / Vorspül / / 1 cold rinse (to avoid food scraps from sticking to dishes). * Testing programme according to IEC 436/DIN 44990 "65° Normal-Programm" with detergent type A and "50° Eko-Programm" with detergent type B; Recommended setting of rinse aid: 3. Ensure the filter is in its original position, the handle of the drain filter should be pointing towards the front of the appliance. The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. 90° B C MA05 39 PMC01GB External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). ENGLISH Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water; 2. Leave the door ajar to prevent the formation of any unpleasant smells; 4. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge; 4. [. . . ] A distance of 2 mm should be allowed between the top of the dishwasher and the counter top. Adjusting the height of the appliance To adjust the height proceed as follows: 1. The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right. A pad is supplied for the rear foot to make sliding the appliance in and out of the recess easier. 818 ÷ 878 5 57 x ma 596 0 57 x ma 5 55 x ma To fit the pad, press it onto the foot. If required, the dimensions of this pad can be reduced by breaking it where marked. [. . . ]