User manual JUNO SDU1130B

[. . . ] To connect the pipe fit the coupling ring C in the outlet selected. Use cover D to close the unused outlet (Fig. Choosing the exhausting pipe The coupling ring C has a diameter of 120mm. [. . . ] Check that the small tab (1) coincides with the arrow (2) printed on the conveyor. Turn in clockwise direction. Electric connection Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. The hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. Installation When installed, the hood must be not less than 60 cm. above gas or mixed-fuel burners. Warning! -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. Make four holes at the bottom of the cabinet . Remove the screws from the container on the side of the conveyor. Fit the four 4. 2x35 screws supplied, from inside the cabinet in the holes on the appliance. Refit the exhaust grid. it from the slots to which it is attached (Fig. When the filters are washed, the grid should also be cleaned with warm water and biodegradable detergent. Charcoal filter This filter dissolves cooking odours. The charcoal filter must never be washed. It should be changed every 4 months in normal use. Mounting and replacing the charcoal filter: a. Disconnect the hood from the electricity. Turn the filter in the counterclockwise direction (2). Using the hood JDU 1230 - JDU 1450 The hood is provided with a 3-speed motor. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. [. . . ] To replace the filter, proceed as follows: a. Slide the two side latches to release the grid (Fig. Remove the grid completely , pull the right side of the grid forward and unhook 8 Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. [. . . ]