User manual JUNO SSI0360S

[. . . ] Before installing and using the appliance read this user's instruction book carefully. it contains safety precautions , hints , information and ideas. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. The symbols below help you to find things more easily: Safety precautions Warnings and information at this symbol serve safety for you and your appliance. [. . . ] Theappliance shall not be discarded together with the urban refuse and rubbish. Information on your local disposal sites may be obtained from your municipal authorities. Remove the plug and ensure that any locks or catches are removed, to prevent young children being trapped inside. The materials marked with the symbol are recyclable. Wait 4 hours before connecting the appliance to allow the oil to flow back in the compressor. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Remove safety elements used for transportation. The temperature regulator allows you to adjust the temperature inside the refrigerator according to use and external conditions. The following effects are of significance in respect of the interior temperature: ambient temperature quantity and temperature of the food stored; frequency with which the door is opened and how long it is left open the location of the appliance. Insert the plug into the wall socket and turn the thermostat knob clockwise beyond position< O > (OFF). If it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance. Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Bleeding part of the moisture of cooling chamber in form of frost and ice goes with the operation of the refrigerator. Thick frost and ice has an insulating effect, so it reduces cooling efficiency as the temperature increases and it needs more energy. At this type of appliance defrosting cooling compartment is automatic without any external intervention. The thermostatic control interrupts the operation of compressor at regular intervals for more or less time - during this cooling is interrupted - temperature of the cooling compartment increases and defrosting occurs. after defrosting the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet into the evaporative tray maintained on the top of compressor and evaporates due to warmth of it. Check and clean the outlet of melting water coming during Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The most typical case of clogging up in the defrost water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of cooling compartment and freezes to it. [. . . ] When the refrigerator is not in use In case the appliance will not be used for a long time follow these steps: Break the circuit of the appliance. Leave the door open to avoid a build up of air inside. Problems may be due to causes which can easily be solved before calling the Technical Service. please follow these instructions: SYMPTOM Door does not close SOLUTION Weight surpasses the storage limit of the door shelf so spread weight more evenly or take some products out. [. . . ]