User manual JURA IMPRESSA E85

[. . . ] IMPRESSA E80/85 Instructions for use Art. 64286 7/05 JURA IMPRESSA E80/85 Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. JURA Elektroapparate AG, CH-4626 Niederbuchsiten, Internet http://www. jura. com = Note = Important = Tip Fig. [. . . ] READY Place a cup under the replaceable hot water jet (17). Open the steam / hot water draw-off tap (15) (Fig. For example: 140 ML WATER Adjust the required water quantity by turning the Rotary Switch (1). For example: 200 ML WATER If the required water quantity is reached, the following message is displayed: SHUT TAP Close the steam / hot water draw-off tap (15). READY Before CLOSE TAP water may still escape the system. 12. Drawing off steam To ensure perfect operation, clean the 2-stage frothing jet (16) regularly. Hold the jet at the top and at the bottom end and screw it apart (Fig. Thoroughly rinse the 3 parts under running water. Make sure the nozzle has engaged properly. If the nozzle is clogged with dried milk or has not been attached properly, it might suddenly come off during operation. Install the replaceable 2-stage frothing jet (Fig. Do not replace the replaceable steam/hot water jet (16) directly after drawing off steam, because the jet is hot after the draw-off operation. Steam can be used for heating liquids and frothing milk for cappuccino. Make sure that the replaceable steam/frothing jet (16) is pushed upwards when liquids are heated. To froth liquids, push the 2-stage frothing jet downwards, turning it slightly. During frothing some water will escape the system before the actual frothing process. At the start of the steam draw-off operation there can be splashing The steam jet becomes hot. READY Place a cup under the 2-stage frothing jet (16) and immerse it in the milk to be frothed or the liquid to be heated. Press the steam pre-selection key (7). HEATING STEAM To draw off steam, open the steam/hot water draw-off tap (15) (Fig. You can adjust the steam draw-off time individually by turning the Rotary Switch (1) until the required SEC are displayed. For example, 35 SEC If you do not change the steam draw-off time settings using the Rotary Switch (1), the machine will use the settings last adjusted During the steam draw-off operation, the message STEAM is displayed When the steam quantity is reached, the message SHUT TAP is displayed Close the steam / hot water draw-off tap (15). READY Before SHUT TAP, steam may still escape the system. [. . . ] Preheating cups You can preheat the cups using hot water or steam. The smaller the coffee you want to draw off, the more important preheating is. Sugar and cream Stirring coffee/tea will result in heat being released. Adding refrigerated cream or milk will reduce the temperature of the coffee significantly. E 21 21. [. . . ]