User manual JURA IMPRESSA X30

[. . . ] IMPRESSA M30 IMPRESSA Scala IMPRESSA Scala Vario IMPRESSA X30 Instructions for use Art. 62445 11/99 Jura Impressa M30 English . 6 ­ 17 Legend : = Note = Important = Tip Jura Elektroapparate AG, CH-4626 Niederbuchsiten, Internet http://www. juraworld. com Kundendienst Telefon 062 389 82 33 Fig. 9 Operating elements Jura Impressa M30 11 12 13 10 14 15 16 17 18 19 9 8 7 6 5 4 3 1. [. . . ] Press draw-off button for about 3 seconds and choose the required setting by pressing selector switch. Push button to store level in memory . 6. Adjusting water volume Water volume is infinitely adjustable by means of the selector switch (3). drawing off time for steam is about 8 minutes. This water should be drawn off before drawing off steam. When steam is first drawn off, there is a possibility of spattering. Avoid direct contact with the skin. 7. 1 Drawing off espresso/strong coffee Place 1 cup under coffee-spout (16) and press the required button until the warning lamp lights up. You can only draw off 1 cup of strong coffee at a time. 7. 2 Drawing off powder coffee Press selector switch. Warning lamps and light up. Now put 1 or 2 levelled spoons of pre-ground coffee powder into the filling funnel for pregrownd coffee powder (12) (Fig. Place 1 or 2 cups under coffee-spout (16) and press the coffee button required. 10 8. 1 Resetting to stand-by status Please the selector switch (14) once more. The small light in the selector switch (14) goes off. This process is automatic and takes a few seconds. Clean the pivoting nozzle with a moist cloth after every draw-off of steam. 11. 2 Empty grounds container The coffee grounds are collected in the grounds container. When the warning lamp lights up, the draw-off buttons are blocked and you must empty the grounds container. Empty and clean the drip tray and the grounds container. Put the drip tray and the grounds container back in again. Whenever grounds container is emptied, empty drip tray too. 9. Drawing off hot water Place a cup under the pivoting nozzle (17) and turn the selector switch for steam/hot water (15) to the position. During the draw-off of hot water, the warning lamp flashes. In order to end the process, turn the selector switch for steam/hot water (15) back to the position. When hot water is first drawn off, there is a possibility of spattering and the risk of scolding. Avoid direct contact with the skin. 11. 3 Drip tray is missing If the drip tray is not replaced correctly, warning lamp flashes. When the drip tray is outside the machine you can take the opportunity to clean the inside of the machine. [. . . ] Turn the selector switch for steam/hot water (15) to the tion. posi- The de-scaling process is continued. The de-scaling solution is guided into the drip tray in the inside of the machine. The warning lamp flashes, the warning lamp , light up. Empty the drip tray and the grounds container and put both of them back in again. [. . . ]