User manual JURA NESPRESSO N30

[. . . ] Avoid touching the electrical cord as well as any other part which may become hot during the use of the machine (steam nozzle, chrome portion of capsule holder). Keep the machine and the electrical cord out of children's reach. Equally included are 4 varieties of Nespresso coffee (4 x 10 capsules) allowing you to use the machine immediately. For further information concerning the different varieties of Nespresso coffee and to order capsules, contact your Nespresso Club at the address found on your machine or in the «Welcome-pack». [. . . ] First prepare a Nespresso in a cappuccino cup filling it only one-third full. Remove the capsule holder from the spout ring, discard the used capsule and reinsert the empty capsule holder in the spout ring. press the steam / hot water switch to the position (16). Once the yellow temperature control light goes off, the machine is ready for use. Plunge the steam nozzle into the receptacle and turn the function knob to the position on the left (17). The yellow temperature control light will go on. Maintain the end of the nozzle under the surface of the milk during the entire procedure ensuring that it does not touch the base of the receptacle. stop the steam by turning the function knob to the «0» position. The yellow temperature control light will go off. The steam nozzle is useful in making frothed milk for a cappuccino, or for heating a liquid. Pour approximately 1 dl of cold whole milk into a sufficiently high pot (of not more than 0. Turn the function knob again to the position on the left for just a second in order to eliminate any residual milk that otherwise can block the steam nozzle. Wipe the integrated frothing attachment with a clean damp cloth. The yellow temperature control light will go off. remove the receptacle and pivot the steam nozzle over the drip tray. Wipe the steam / hot water nozzle with a clean damp cloth immediately after its use. Important: To extract a Nespresso after having used the steam, let the machine cool down. To do this, insert the empty capsule holder into the spout ring, place a receptacle under the coffee spout and run the equivalent of one or two large cups of water by turning the function knob to the position on the right. return the function knob to the «0» position. Once the yellow temperature control light goes off, the machine is ready for use. You can also heat liquids thanks to the steam / hot water nozzle on this machine. Important: To extract a Nespresso after having used the steam, let the machine cool down. [. . . ] To do this, remove the capsule holder from the spout ring, place a receptacle under the coffee spout and turn the function knob to the position on the right. If water does not flow freely (with two clearly visible water jets), clean and unblock the capsule cage (see the section on "Cleaning the Capsule Cage"). Clean the capsule holder preferably with the product specially conceived for this purpose (see the section on "Cleaning"). Problem: The milk for a cappuccino is not frothy enough. [. . . ]