User manual JVC 4VN-990

[. . . ] Before use, please read the safety information and precautions contained in the following pages to ensure safe use of your new Digital Still Camera. The AA-V37 AC Power Adapter should be used with: AC 120 V`, 60 Hz in the USA and Canada, AC 110 – 240 V`, 50/60 Hz in other countries. CAUTION (applies to the AA-V37) TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION (s’applique à l’AA-V37) POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND. Using This Instruction Manual • All major sections and subsections are listed in the Table Of Contents (੬ pg. [. . . ] Select “6M PRO S” with the MODE switch. •“6M PRO S” appears on the LCD panel. Confirm that the self timer is set to “1 second“. 4 5 Point the lens at the subject, position yourself, and half-press the Shutter button. • To display the image on the LCD screen while shooting, press the DSP button. Press the Shutter button all the way to take the picture. • The shoot standby lamp (green) goes off when the shooting has finished. NOTES: ● The picture size is automatically set to 2032 x 1536 with this mode. ● Due to large memory files created when shooting a picture of uncompressed quality in this mode, it is recommended to use a Memory card with the capacity more than 16MB. ● It takes a few seconds until the shooting finishes because this mode uses the exposure twice. Do not move the object and the camera until the shooting finishes completely. O 4 FF M V EN 47 DR Pro-Still (Wide Range Mode) The camera can expand its apparent dynamic range by combining different exposures of an extremely high contrast subject. This mode uses the self timer to shoot a still picture. Use a tripod to prevent problems caused by shaky hands. 3 2 4, 5 1 SET O 4 FF M V 1 2 3 Turn the Power dial to “M”. This feature is useful if you want to send a short video by e-mail. 2, 3 1 T SE 4 OFF M V 1 2 3 Turn the Power dial to “V”. •Hold the Lock button down while turning the Power dial. •“VIDEO” appears on the LCD panel. •To display the image on the LCD screen while shooting, press the DSP button. Press the Shutter button all the way to shoot the video. •The flash standby lamp (red) lights during the video shooting. •Video shooting will stop automatically after about 20 seconds. Press the Shutter button again to stop the video shooting before 20 seconds are up. •While the video file is stored in the Memory card, the flash standby lamp (red) flashes, and then goes off when the recording has finished. Do not operate the camera while the light flashes. NOTES: ● It is not possible to record the sound when shooting video. ● It is not possible to use the flash for video shooting. [. . . ] WHAT WE WILL DO: If this product is found to be defective, JVC will repair or replace defective parts at no charge to the original owner. Such repair and replacement services shall be rendered by JVC during normal business hours at JVC authorized service centers. Parts used for replacement are warranted only for the remainder of the Warranty Period. All products and parts thereof may be brought to a JVC authorized service center on a carry-in basis except for Television sets having a screen size 25 inches and above which are covered on an in-home basis. [. . . ]