User manual JVC A-X500VB parts list

[. . . ] Switch off and withdraw the mains plug when making or changing connections. Do consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment. Do be careful with glass panels or doors on equipment. DON'T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in any way—switch off—withdraw the mains plug and consult your dealer. DON'T remove any fixed cover as this may expose dangerous voltages. DON'T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for unattended operation or has a standby mode. Switch off using the switch on the equipment and make sure that your family know how to do this. Special arrangements may need to be made for infirm or handicapped people. DON'T use equipment such as personal stereos or radios so that you are distracted from the requirements of road safety. It is illegal to watch television when driving. DON'T listen to headphones at high volume as such use can permanently damage your hearing. DON'T obstruct the ventilation of the equipment, for example with curtains or on soft furnishings. [. . . ] The image on the LCD monitor will be enlarged. To deactivate the digital zoom function, press the same button again. Then, press the shutter button fully down. (For details, see ‘Shooting Basics’) (2) Using Flash The flash is designed to fire automatically when required. To suit the different conditions, however, you can change the flash mode. Press the flash button until the desired flash mode (AUTO, RED-EYE REDUCTION, FILL-IN, OFF) is indicated by the cursor. Procedures 1. Select the Camera mode with the MODE button. Press the flash button until the desired flash mode (AUTO, RED-EYE REDUCTION, FILL-IN, OFF) is indicated by the 4. Then press the shutter button fully down. (For details, see ‘Shooting Basics’) AUTO Flash Red-Eye Reduction (RER) Fill-In Flash Flash Off cursor. The flash fires automatically according to the photography conditions. Use this mode to avoid the red-eye effect when photographing people or animals in low light conditions. The flash fires regardless of the surrounding brightness. (Refer to ‘Getting Started’) 2. Toggle on the MODE button to select the Video Clip Mode [ ]. Ensure that the LCD monitor is activated. (Toggle the LCD/OK button to activate/deactivate it). The viewfinder cannot be used for video clip recording. Press the shutter button to start recording. Press the shutter button again to stop recording. To continue shooting, repeat the above steps 4 to 5. Notes: l l l l l l l l l l l l l When the storage memory is full, you may either delete the video clips that are no more required, or insert a new memory card. The remaining shooting time shown on the Status LCD is an approximate value based on the currently accessed memory size. The actual number of seconds available for shooting also depends on the shooting conditions. The value does not necessarily decrease by the second. [. . . ] When you are unable to Format or Delete: Possible Cause The card is write protected. Possible Cause The flash was set at FILL-IN flash mode. The subject was too bright When photographs turn out too dark: Possible Cause The flash was obstructed by fingers or other objects. The subject was too far from the camera for the flash to be effective. [. . . ]