User manual JVC AAV100U-AA-V100 INSTRUCTIONS MANUAL

[. . . ] CAUTION: TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. CAUTIONS: · If used near a radio, this unit may interfere with reception. · Prevent inflammables, water and metallic objects from entering the unit. · Do not disassemble or modify the unit. [. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. EN-3 NOTE: The rating plate (Serial number plate) is on the bottom of the unit. USING HOUSEHOLD AC PLUG ADAPTER In case of connecting attached Power Cord Plug to AC wall outlet other than American National Standard C73 series type, use an AC plug adapter, so called "Siemens Plug", as shown below. For this AC plug adapter, Plug adapter (optional) consult your nearest JVC dealer. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. When the equipment is installed in a cabinet or on a shelf, make sure that it has sufficient space on all sides to allow for ventilation (10 cm (3-15/ 16") or more on both sides, on top and at the rear). (If the ventilation holes are blocked by a newspaper, or cloth etc. the heat may not be able to get out. ) No naked flame sources, such as lighted candles, should be placed on the apparatus. When discarding batteries, environmental problems must be considered and the local rules or laws governing the disposal of these batteries must be followed strictly. The apparatus shall not be exposed to dripping or splashing. Do not use this equipment in a bathroom or places with water. Also do not place any containers filled with water or liquids (such as cosmetics or medicines, flower vases, potted plants, cups etc. ) on top of this unit. (If water or liquid is allowed to enter this equipment, fire or electric shock may be caused. ) EN-4 CHARGING THE BATTERY PACK Protruding part Battery pack CHARGE indicator POWER indicator To AC outlet AC Power Adapter/Charger DC OUT connector 1 2 3 Make sure you unplug the camcorder's DC cord from the AC Power Adapter/Charger. Plug the AC Power Adapter/Charger's power cord into an AC outlet. Remove the battery pack's protective cap. [. . . ] When charging a brand new Battery Pack, or one that's been in storage for an extended period, the Charging Indicator may not come on. In this case, remove the Battery Pack, then reattach and try charging again. If you connect the DC Cord to the DC Connector while a Battery Pack is being charged, power will be supplied to the camcorder and charging will end incomplete. Vibration noise can sometimes be heard coming from the inside of the AC Power Adapter/Charger. [. . . ]