User manual JVC AV-28X35

[. . . ] AV-32X35HKE/AV-28X35HKE LCT1359-001A-U 0103-T-CR-JMUK Colour Television AV-32X35HKE AV-28X35HKE INSTRUCTIONS © 2003 VICTOR COMPANY OF JAPAN, LIMITED Thank you for buying this JVC colour television. To make sure you understand how to use your new TV, please read this manual thoroughly before you begin. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: · Operate only from the power source specified (AC 220 ­ 240 V, 50 Hz) on the unit. · Avoid damaging the AC plug and power cord. [. . . ] 1 Choose DigiPure Pro 2 Press the 5 buttons to choose a setting. Then press the a button AUTO: The TV will automatically adjust the level of the DigiPure effect to match the amount of noise in the picture, giving the best possible picture. MIN: The level of DigiPure effect is set to the minimum. When you set the DigiPure Pro function to AUTO and notice some noise, change the setting from AUTO to MIN. · The MIN setting is not suitable for highquality pictures which contain very little noise. D1015-EN DIGITAL VNR The DIGITAL VNR function cuts down the amount of `noise' (`snow' or interference) in the original picture. You can choose from the three DIGITAL VNR function settings of AUTO, MIN and MAX. The TV and external input may be given different DIGITAL VNR settings. AUTO: The TV will automatically adjust the level of the DIGITAL VNR effect to match the amount of noise in the picture, giving you the best possible picture. · If you set the DIGITAL VNR effect too high it can make the picture less sharp. It is recommended to use the AUTO setting if you can. MIN: The level of the DIGITAL VNR effect is set to the minimum. If you set the DIGITAL VNR function to AUTO but feel that the sharpness of the original picture has not been reproduced fully, change the setting from AUTO to MIN. · The MIN setting is not suitable for lowquality pictures which contain a lot of noise. MAX: The level of the DIGITAL VNR effect is set to the maximum. If you set the DIGITAL VNR function to AUTO but still notice some noise, change the setting from AUTO to MAX. · The MAX setting is not suitable for highquality pictures which contain very little noise. 21 PICTURE FEATURES MAX: The level of DigiPure effect is set to the maximum. If you set the DigiPure Pro function to AUTO but feel that the original picture quality has not been reproduced fully, change the setting from AUTO to MAX. · The MAX setting is not suitable for lowquality pictures which contain a lot of noise. OFF: The DigiPure Pro function is turned off. · The AUTO function may not work properly if you have poor signal quality. If the picture is abnormal in the AUTO function, choose another colour system manually. · You cannot choose NTSC 3. 58 or NTSC 4. 43 for programme number PR 0 (AV) to PR 99. COLOUR SYSTEM The colour system is chosen automatically. However, if the picture is not clear or no colour appears, choose the colour system manually. COLOUR SYSTEM MOVIE THEATRE The MOVIE THEATRE function displays a cinema film picture more smoothly and naturally on the screen. [. . . ] · A picture may be tilted due to the earth's own magnetic field. If so, use the "PICTURE TILT (Only for AV32X35HKE)" on page 23 to correct the tilt. · It takes a short period of time from the time an operation such as changing channels is performed until an image is displayed. This is the time required for the image to stabilize before it can be displayed. [. . . ]