User manual JVC AV-32T4SA-AV-32T4 Instruction Manual

[. . . ] AV-32T4SA COLOUR TELEVISION INSTRUCTIONS LCT1673-001A-H Thank you for buying this JVC colour television. To make sure you understand how to use your new TV, please read this manual thoroughly before you begin. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: · Operate only from the power source specified (AC 220 ­ 240 V, 50 Hz) on the unit. · Avoid damaging the AC plug and power cord. [. . . ] 2 : lower 3 : higher BRIGHT You can adjust the picture brightness. 2 : darker 3 : brighter SHARP You can adjust the picture sharpness. 2 : softer 3 : sharper 18 PICTURE menu FEATURES Choose FEATURES and press the a or 3 button to display the sub-menu. FEATURES AUTO VNR COLOUR SYSTEM 4:3 AUTO ASPECT TV OK COLOUR SYSTEM The colour system is chosen automatically. However, if the picture is not clear or no colour appears, choose the colour system manually. Then press the a or 3 button The sub-menu of the COLOUR SYSTEM function appears. COLOUR SYSTEM PAL TV OK MIN D1015-EN AUTO VNR VNR stands for "video noise reduction". AUTO: This mode reduces any "noise" (interference or snowing) in the current picture. The function also adjusts the optimum sharpness of the picture (SHARP). OFF: The AUTO VNR function is cancelled. If you set the mode to AUTO but feel that the sharpness of the original picture has not been reproduced fully, change the mode to OFF. However, any noise remaining in the original picture may be emphasized. MIN: This mode reduces any noise irrespective of state of the picture. If you set the mode to AUTO but feel that the sharpness of the original picture has not been reproduced, change the mode MIN. However, any noise remaining in the original picture may be emphasized a little. And this may reduce the sharpness of the picture a little. MAX: This mode always reduces any noise as much as possible, irrespective of state of the picture. When you set the mode to AUTO but still notice some noise, change the mode to MAX. However, this may reduce the sharpness of the picture. D0016-EN 2 Press the 5 buttons to choose the appropriate colour system. Then press the a button PAL: PAL system SECAM: SECAM system NTSC 3. 58: NTSC 3. 58 MHz system NTSC 4. 43: NTSC 4. 43 MHz system AUTO: This function detects a colour system from the input signal. You can only use this when you are viewing a picture from programme number PR 0 (AV), or an EXT terminal. · The AUTO function may not function properly if you have poor signal quality. If the picture is abnormal in the AUTO function, choose another colour system manually. · When in the Programme numbers PR 0 (AV) to PR 99, you cannot choose NTSC 3. 58 or NTSC 4. 43. 19 PICTURE menu 4:3 AUTO ASPECT You can choose one of three ZOOM modes, REGULAR, PANORAMIC or 14:9 ZOOM, as the ZOOM mode for the normal picture (4:3 aspect ratio). [. . . ] For precautionary purposes, request your service technician to inspect it. · Touching the screen may cause you feel a slight electric shock due to its static electricity. It is an unavoidable phenomenon due to the construction of the picture tube. You can rest assured that this static discharge does not have harmful influence over the human body. Poor sound · Have you adjusted BASS or TREBLE properly? [. . . ]