User manual JVC CS-AW6040

[. . . ] Do not view directly with optical instruments. Adjust the volume so that you can hear sounds outside the car. Driving with the volume too high may cause an accident. [European Union only] These symbols indicate that the product and the battery with this symbol should not be disposed as general household waste at its end-of-life. [. . . ] Once you finished entering the number, press the control dial to confirm. Press and hold to activate voice dial operation directly if only one phone is connected. If two phones are connected, pressing and holding will enter "Phone list" screen. Turn the control dial to select a phone to activate voice dial operation, then press to confirm. ⷠOnly accessible when the connected mobile phone has the voice recognition system. ⷠ"Not Support" appears if the connected phone does not support this feature. if "Settings" is selected in step 2 . Turn the control dial to select an item (see the following), then press the control dial to confirm. The following settings are applicable to the paired device. If another device is paired, make the settings again. (To copy the phonebook memory, see <Phonebook Trans> on page 19. Using the remote controller 2 / 3 : [Press] Reverse skips or forward skips. Repeat step 2 to select a setting item (see table on page 19), then repeat the procedure to change the setting accordingly. Delete Pairing Phonebook Trans Turn the control dial to select the device you want to delete, then press the control dial to confirm. (page 14) You can copy the phonebook memory of a mobile phone into the unit (via OPP). You may need to enter the PIN code or verify passkey from the mobile phone to do pairing. you can transfer a maximum of 400 numbers. You can change the PIN code of your choice before pairing (1-digit to 6-digit number). [ Initial: 0000 ] Turn the control dial to select a number, press 4 /¢ to move to the entry position, then press the control dial to confirm the entry. On : The connection is established automatically with the registered Bluetooth device when you turn on the unit. / Off : The unit does not connect the Bluetooth device automatically. *1 Will not display if two Bluetooth phones are connected at the same time. [. . . ] Make sure you have entered the same PIN code to both the unit and target device. Tracks do not play back in the order you have intended them to play. The elapsed playing time is not correct. Tracks/folders are not played back in the order you have intended. [. . . ]