User manual JVC CS-AW6240

[. . . ] Do not view directly with optical instruments. Adjust the volume so that you can hear sounds outside the car. Driving with the volume too high may cause an accident. [European Union only] These symbols indicate that the product and the battery with this symbol should not be disposed as general household waste at its end-of-life. [. . . ] Turn the control dial to select a number or character (see table below), press 4 /¢ to move to the entry position. Once you finished entering the number, press the control dial to confirm. Speak the name (registered words) you want to call when "WAIT VOICE" = "[Device name]" scrolls on the display. ⷠPress and hold to activate voice dial operation directly if only one phone is connected. If two phones are connected, pressing and holding will enter "Phone list" screen. Turn the control dial to select a phone to activate voice dial operation, then press to confirm. ⷠOnly accessible when the connected mobile phone has the voice recognition system. ⷠ"NOT SUPPORT" appears if the connected phone does not support this feature. Turn the control dial to select an item (see the following), then press the control dial to confirm. The following settings are applicable to the paired device. If another device is paired, make the settings again. [ Initial: 0000 ] Turn the control dial to select a number, press 4 /¢ to move to the entry position, then press the control dial to confirm the entry. ON : The connection is established automatically with the registered Bluetooth device when you turn on the unit. / OFF : The unit does not connect the Bluetooth device automatically. *1 Will not display if two Bluetooth phones are connected at the same time. *2 Displayed only when a Bluetooth phone/audio player is connected. You can connect an Apple iPod/iPhone using the USB 2. Apple iPod/iPhone USB cable from the rear of the unit and/or USB 2. Avoid using the iPod/iPhone if it might hinder your safety driving. ⷠMake sure all important data has been backed up to avoid losing the data. For <APP MODE>, applicable only for some audio applications. Repeat this step until the desired track is selected. [. . . ] If the message does not disappear, turn off and turn on the unit, then connect the device again (or reset the unit). (page 3) Reset the unit and try the operation again. If "HW ERROR" appears again, consult your nearest JVC IN-CAR ENTERTAINMENT dealer. Symptom The iPod does not turn on or does not work. [. . . ]