User manual JVC GD-17L1G-U-GD-17L1 Instruction Manual

[. . . ] INSTRUCTIONS LCD DISPLAY MONITOR GD-19L1G GD-17L1G Thank you for purchasing this JVC LCD display monitor. Before using it, read and follow all instructions carefully to take full advantage of the monitor's capabilities. (* "LCD" stands for Liquid Crystal Display. ) For Customer Use: Enter below the Serial No. which is located on the rear of the cabinet. [. . . ] So if the monitor will not be used for an extended period, be sure to turn it off. Caring for and Cleaning the Monitor To maximize screen life and prevent damage to the LCD panel, we recommend that you: Turn the monitor off when you are not using this monitor for a long period of time. Don't press, rub, or poke the monitor with your finger or other object. Your LCD module is a high-quality optical device that requires special care when cleaning. Warning Don't use liquid, aerosol, or abrasive cleaning solutions to clean the screen. To clean the screen: 1. Gently dust the screen with a dry, soft, line-free cloth. Note: If the screen is still dirty, you can dampen the cloth with several drops of distilled water. Make sure the LCD panel is completely dry before you turn the monitor on. Connecting the monitor to the PC When you connect the monitor to a PC, you might be requested to install the specific driver. In this case do the following: -use the driver attached with the video card of the PC you use. or -set the monitor as standard monitor in the PC menu. Recommended modes 1280 x 1024 at 60Hz. 11 ENGLISH Using the Menu This chapter contains information about how to change monitor settings for your LCD Monitor. It is designed with an menu to help you easily adjust to its optimum performance. Note: In the PC mode, do the "AUTO ADJUST" setting first, before adjusting any settings. For details, see "AUTO ADJUST" on page 17. Menu Operation 1. Display the main menu With the remote control: Press the `MENU' button. To exit the main menu, press the `MENU' button again. With the control buttons on the front panel: Press the `MENU' button. To exit the main menu, press the `Up'() or `Down'() button to select the `Exit', then press the `MENU' button. MAIN MENU LUMINANCE PICTURE ADJ. Display the menu you want to use With the remote control: Press the `Up'() or `Down'() button to choose the menu, and then press the `SELECT' button. To return to the main menu, press the `MENU' button. With the control buttons on the front panel: Press the `Up'() or `Down'() button to choose the menu, and then press the `MENU' button. To return to the main menu, press the `Up'() or `Down'() button to select the `Exit', then press the `MENU' button. FUNCTION SEL. Display the sub-menu of the item you want to use With the remote control: Press the `Up'() or `Down'() button to choose the item, and then press the `SELECT' button or `' or `' button. To return to the menu, press the `MENU' button. [. . . ] Check that your graphic card outputs the analog RGB signal. The message "out of range!" appears on my monitor. This message appears when the input signal is beyond the monitor capability. Set your PC to a supported video mode; recommended mode is 1280 x 1024 at 60Hz. [. . . ]