User manual JVC GY-DV500

[. . . ] INTRODUCTION CONTROLS, INDICATORS AND CONNECTORS BASIC SYSTEM CONNECTIONS AND ADJUSTMENTS POWER SUPPLY PREPARATIONS SETTING AND ADJUSTMENTS BEFORE SHOOTING DV CAMCORDER SHOOTING OPERATION GY-DV500 INSTRUCTIONS PLAYBACK MODE TIME CODE OPERATION S. S. F. (Super Scene Finder) yyy , , , yyy , , , * The illustration shows the GY-DV500 DV Camcorder with the optional lens viewfinder attached. Thank you for purchasing this JVC product. Before operating this unit, please read the instructions carefully to ensure the best possible performance. For Customer Use : Enter below the Serial No. Retain this information for future reference. [. . . ] Turn ON the power and set the counter display to the date/ Time display (COUNTER switch: TC) Hour Min. · Set the VCR Setup Menu item No. 516 DISPLAY SELECT to "CLOCK". See "Displaying and Setting VCR Setup Menus" on page 67. See "VCR Setup Menu Contents" on page 69. HOLD 2. Set the COUNTER switch to TC or UB. To set the time: Set the switch to TC. The time (Hour, Min. , Sec. ) is indicated on the counter display. (24-hour clock system) To set the date: Set the switch to UB. The date (Month, Day, Year) is indicated on the counter display. H M S HOLD H M S 3. Press the HOLD button to enter the setting mode. H M S The "HOLD" indicator lights up on the display to indicate that the unit is in the setting mode. The leftmost digit on the counter blinks. 4. Set the date and time. Date display (COUNTER switch: UB) Month Day Year HOLD · Each time the ADVANCE button is pressed, the value of the blinking digit increases. · Each time the SHIFT button is pressed, the digit to the right of the currently blinking one starts blinking. When pressed while the rightmost digit is blinking, the leftmost digit starts blinking again. Repeat the above procedure to set the value of all the digits. HOLD 5. To decide the set date and time data, press the PRESET button. The "HOLD" indicator on the display turns off and the date/ time display stops blinking. Memo: To display and set the time code or user's bit, set the VCR Setup Menu item No. 516 DISPLAY SELECT to "TC". 41 6. SETTING AND ADJUSTMENTS BEFORE SHOOTING 6-1 Camera Settings 1. POWER ON 3. OPERATE/WARNING LIGHT RESET MONITOR SELECT ALARM ON OFF FILTER 1 3200k 2 5600k 3 5600k+ND SHUTTER STATUS COUNTER CTL TC UB 1 First place a charged battery pack in the battery case on the rear section of the unit. If battery pack is not used, connect DC power to the DC INPUT connector on the rear section of the unit using the AC power adapter (AAP250) to supply DC 12 V current. [. . . ] Use the side section's CH2 recording level control for this purpose. · Is the SERVO indicator or "SYNC INH" displayed on the counter display?If so, check the input sync signal. 91 14. OTHERS 14-2 Hour Meter Display The unit can display the accumulated running time of the head drum as hour meter data on the counter display. [. . . ]