User manual JVC IF-CF01PNG

[. . . ] only) CAUTION: Changes or modifications not approved by JVC could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] · Slot cover (x 1): For covering the blank slot. · Label (x 1): 7 Preparation · · · · Wear gloves to protect your hands from metal parts on the Input Card's board. You will need a 6 mm Phillips screwdriver. Turn off the monitor's main power and unplug the power cable from the AC outlet. Place the monitor with its LCD panel side down on a soft cloth so as not to damage the LCD panel. 7 Cautions · Do not touch the terminals or board pattern of the Input Card to keep it from being damaged by static electricity. · Do not damage the Input Card's connection terminal. · Do not put anything into the Input Card's holes or intakes. · Do not force the Input Card into the monitor's slot. · Attach the slot cover on the monitor's slot in which no Input Card is installed. · Attach the Input Card before mounting the monitor on the stand or wall mounting unit. Installation 7 Installation procedure 1. Remove the slot cover from the slot on the bottom side of the monitor. Slot cover The monitor in the illustration is GM-H40L2. 4 Installation (continued) Ex. : When installing only one Input Card Insert 1, then 2. Insert the Input Card into the slot, fitting into the guides inside the slot, so that its panel touches the bottom of the monitor. You can install the Input Card(s) into either left or right slot. When installing, follow the procedure below. · When installing two Input Cards: Install either of Input Cards into the left slot first. · When installing only one Input Card: You need to attach the supplied slot cover to the blank slot. Install either Input Card or the supplied slot cover into the left slot first as illustrated on the right. Panel Slot cover (supplied) or Slot cover (supplied) Guide Panel 3. Secure the Input Card by using the screws removed in Step 1 on the previous page. After installation · Place the supplied labels on the rear panel and the remote control of the monitor as illustrated on the right. ­ On the rear panel: Place the label on the name of the slot into which you have installed the Input Card. [. . . ] 2 On the remote control: When the input signal type for input B is fixed (RGB, COMPO. , or DVI), place the corresponding label on the printing of the input select buttons A and B. 3 On the remote control: Place the label on the printing of the input select buttons (C/D or E/F) for the slot into which you have installed the Input Card. ("NO CARD" is for a blank slot. ) 5 Connection terminal (on the rear side) Attach to the connection terminal in the slot of your monitor. 7 ENGLISH Specifications Model name: Type: Target monitors: Inputs/Outputs: IF-CF01PNG Video Input Card Consult your dealer. [. . . ]