User manual JVC KD-G110

[. . . ] ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. If you need to operate the receiver while driving, be sure to look ahead carefully or you may be involved in a traffic accident. [. . . ] CLASSIC Classical music POPS Light music You can adjust the sound characteristics to your preference. Indication pattern changes as you adjust the level. Boost low and high frequencies to produce a wellbalanced sound at low volume level. *1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including "USER. " *2 If you are using a two-speaker system, set the fader level to "00. " *3 Normally the +/­ buttons work as the volume control. So you do not have to select "VOL" to adjust the volume level. DEMO ON: [Initial]; Display demonstration will be activated automatically if no operation is done for about 20 seconds, [7]. 1 ­ 12, [7] [Initial: 1 (1:00)] 00 ­ 59, [7] [Initial: 00 (1:00)] You can change the maximum volume level of this receiver. LOW PWR: VOL 00 ­ VOL 30 (Select this if the maximum power of the speaker is less than 50 W to prevent them from damaging the speaker. ) HIGH PWR: [Initial]; VOL 00 ­ VOL 50 AREA EU: Select this when using the receiver in an area other than North and South America. (FM: 50 kHz--manual tuning, 100 kHz--auto search; AM: 9 kHz) [Initial]; Select this when using the receiver in North or South America. 15 When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder. Before detaching the control panel, be sure to turn off the power. To minimize this possibility, periodically wipe the connectors with a cotton swab or cloth moistened with alcohol, being careful not to damage the connectors. To keep discs clean A dirty disc may not play correctly. If a disc does become dirty, wipe it with a soft cloth in a straight line from center to edge. Do not use any solvent (for example, conventional record cleaner, spray, thinner, benzine, etc. New discs may have some rough spots around the inner and outer edges. If such a disc is used, this receiver may reject the disc. [. . . ] What appears to be trouble is not always serious. Check the following points before calling a service center. Sound cannot be heard from the speakers. Disc can be neither played back nor ejected. [. . . ]