User manual JVC KD-G117

[. . . ] CD RECEIVER - KD-G117 For installation and connections, refer to the separate manual. . " " () " , , " (7) . , , , / . (), , , , , JVC, , . For canceling the display demonstration, see page 7. [. . . ] To minimize this possibility, periodically wipe the connectors with a cotton swab or cloth moistened with alcohol, being careful not to damage the connectors. To keep discs clean A dirty disc may not play correctly. If a disc does become dirty, wipe it with a soft cloth in a straight line from center to edge. · Do not use any solvent (for example, conventional record cleaner, spray, thinner, benzine, etc. ) to clean discs. To play new discs New discs may have some rough spots around the inner and outer edges. If such a disc is used, this receiver may reject the disc. To remove these rough spots, rub the edges with a pencil or ball-point pen, etc. Connector Moisture condensation Moisture may condense on the lens inside the CD player in the following cases: · After starting the heater in the car. · If it becomes very humid inside the car. Should this occur, the CD player may malfunction. · This receiver can play back multi-session discs; however, unclosed sessions will be skipped while playing. General settings--PSM · If you change the "AMP GAIN" setting from "HIGH PWR" to "LOW PWR" while the volume level is set higher than "VOL 30, " the receiver automatically changes the volume level to "VOL 30. " ENGLISH 17 Basic operations · Some CD-Rs or CD-RWs may not play back on this receiver because of their disc characteristics, and for the following causes: ­ Discs are dirty or scratched. ­ Moisture condensation occurs on the lens inside the receiver. ­ The pickup lens inside the receiver is dirty. ­ CD-R or CD-RW on which the files are written with "Packet Write" method. ­ There are improper recording conditions (missing data, etc. ) or media conditions (stain, scratch, warp, etc. ). · CD-RWs may require a longer readout time since the reflectance of CD-RWs is lower than that of regular CDs. · Do not use the following CD-Rs or CD-RWs: ­ Discs with stickers, labels, or protective seal stuck to the surface. ­ Discs on which labels can be directly printed by an ink jet printer. Using these discs under high temperatures or high humidities may cause malfunctions or damages to discs. Troubleshooting ENGLISH What appears to be trouble is not always serious. Check the following points before calling a service center. Symptoms · Sound cannot be heard from the speakers. General Causes The volume level is set to the minimum level. Connections are incorrect. Remedies Adjust it to the optimum level. · Insert a finalized CD-R/ CD-RW. · Finalize the CD-R/ CD-RW with the component which you used for recording. Stop playback while driving on rough roads. [. . . ] . : "TRK RPT" DISC RND : . . RND OFF: : "DISC RND" 11 CCK (C-EQ: ) CCK , . USER ROCK : ( ) ~ BAS*1 TRE*2 LOUD*3 00 +03 00 +01 OFF ON CLASSIC POPS : "ROCK" +01 +04 +02 ­02 +01 00 OFF OFF ON HIP HOP : JAZZ +02 +03 OFF *1 BAS: *2 TRE: *3 LOUD: 12 . BAS*1 ( ) TRE*1 ( ) ­06 (. ) . +06 (. ) FAD*2 () . : "TRE" R06 ( ) F06 ( ) L06 ( ) R06 ( ) 2 BAL () . . LOUD ON LOUD*1 J () LOUD OFF . 00 (. ) 30 50 (. )*4 *1 (C-EQ), "USER" (). [. . . ]