User manual JVC KD-G207

[. . . ] CD RECEIVER - KD-G207 For installation and connections, refer to the separate manual. . " " () " , , " (7) . , , , / . (), , , , , JVC, , . · This unit is equipped with the display demonstration. [. . . ] When shipped from the factory, this mode is deactivated. · MUTING 1: Select if this setting can mute the sounds. · MUTING 2: Select if this setting can mute the sounds. · OFF: Cancels the telephone muting. Note: If you change the setting from "HIGH PWR" to "LOW PWR" while listening at a volume level more than 30, the unit automatically changes the volume level to "VOL 30. " · HIGH PWR: You can adjust the volume level from "VOL 00" to "VOL 50. " 17 ENGLISH To select the dimmer mode--DIMMER To select the amplifier gain control --AMP GAIN ENGLISH Detaching the control panel You can detach the control panel when leaving the car. When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder. Attaching the control panel 1 Insert the left side of the control panel into the groove on the panel holder. Detaching the control panel Before detaching the control panel, be sure to turn off the power. 1 Unlock the control panel. 2 Press the right side of the control panel to fix it to the panel holder. 2 Lift and pull the control panel out of the unit. Note on cleaning the connectors: If you frequently detach the control panel, the connectors will deteriorate. To minimize this possibility, periodically wipe the connectors with a cotton swab or cloth moistened with alcohol, being careful not to damage the connectors. 3 Put the detached control panel into the provided case. Connectors 18 TROUBLESHOOTING Symptoms · Sound cannot be heard from the speakers. Causes The volume level is set to the minimum level. Connections are incorrect. Remedies Adjust it to the optimum level. While holding SEL (select), press (standby/on attenuator) for more than 2 seconds to reset the unit. (The clock setting and preset stations stored in memory are erased. ) (See page 2. ) Store stations manually. General · This unit does not work at all. The built-in microcomputer may have functioned incorrectly due to noise, etc. FM/AM · SSM (Strong-station Sequential Memory) automatic preset does not work. · Static noise while listening to the radio. · CD automatically ejects. Signals are too weak. The aerial is not connected firmly. CD is inserted upside down. Connect the aerial firmly. · Insert a finalized CD-R/ CD-RW. · Finalize the CD-R/CD-RW with the component which you used for recording. (See page 13. ) While holding (standby/on attenuator), press 0 (eject) for more than 2 seconds. Be careful not to drop the CD when it is ejected. Stop playback while driving on rough roads. Insert the CD correctly. · CD-R/CD-RW cannot be CD-R/CD-RW is not finalized. · Tracks on the CD-R/CD-RW cannot be skipped. · CD can be neither played back nor ejected. The CD player may have functioned incorrectly. CD Playback · CD sound is sometimes interrupted. You are driving on rough roads. Connections are incorrect. · "NO DISC" appears on the display. No CD in the loading slot. [. . . ] | R06 ( ) , LOUD ON | LOUD OFF . 1: "TRE" ( ) LOUD*1 () . 2: 3 1 2 . VOL*3 () . , , 14. 15 CCK , . (PSM) CCK , , PSM ( ). 3 PSM. 1 4 5 SEL () 2 , PSM. . 2 PSM, . (PSM) · PSM . [. . . ]