User manual JVC KD-G311

[. . . ] Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. If you need to operate the receiver while driving, be sure to look ahead carefully or you may be involved in a traffic accident. [. . . ] Boost low and high frequencies to produce a wellbalanced sound at low volume level. *1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including "USER. " *2 If you are using a two-speaker system, set the fader level to "00. " *3 Normally the +/­ buttons work as the volume control. So you do not have to select "VOL" to adjust the volume level. DEMO ON: [Initial]; Display demonstration will be activated automatically if no operation is done for about 20 seconds, [7]. CLOCK H Hour adjustment CLOCK M Minute adjustment 24H/12H 24 hours or 12 hours time display CLK ADJ Clock adjustment When the received signals from the current station become weak. AF: [Initial]; Switches to another station (the programme may differ from the one currently received), [13]. ON: Using the AF data, the receiver tunes in to another frequency broadcasting the same programme as the original preset RDS station is if the preset station signals are not sufficient. MUTING 1/MUTING 2: Select either one which mutes the sounds while using the cellular phone. Pressing DISP for more than one second can scroll the display regardless of the setting. You can change the maximum volume level of this receiver. LOW PWR: VOL 00 ­ VOL 30 (Select this if the maximum power of the speaker is less than 50 W to prevent them from damaging the speaker. When detaching or attaching the control panel, be careful not to damage the connectors on the back of the control panel and on the panel holder. Before detaching the control panel, be sure to turn off the power. This receiver can be remotely controlled as instructed here (with an optionally purchased remote controller). We recommend that you use remote controller RM-RK60 with your receiver. Make sure there is no obstacle in between. Store the battery in a place where children cannot reach to avoid risk of accident. ⷠTo prevent the battery from over-heating, cracking, or starting a fire: ­ Do not recharge, short, disassemble, or heat the battery or dispose of it in a fire. ­ Do not leave the battery with other metallic materials. ­ Do not poke the battery with tweezers or similar tools. [. . . ] Using these discs under high temperatures or high humidities may cause malfunctions or damages to discs. Network-Tracking Reception requires two types of RDS signals--PI (Programme Identification) and AF (Alternative Frequency) to work correctly. Without receiving these data correctly, NetworkTracking Reception will not operate. ⷠIf a Traffic Announcement is received, the volume level (TA Volume) automatically changes to the preset level. [. . . ]