User manual JVC KD-G807 INSTALLATION MANUAL

[. . . ] *1 , , . C 1 I B / ¤ Bend the appropriate tabs to hold the sleeve firmly in place. , . *1 1 Removing the unit Before removing the unit, release the rear section. . 1 2 3 4 Insert the two handles, then pull them as illustrated so that the unit can be removed. , , , . D H B When using the optional stay / When installing the unit without using the sleeve / In a Toyota for example, first remove the car radio and install the unit in its place. "Toyota" , , , . Fire wall F Dashboard I Stay (option) () Flat type screws (M5 x 8 mm)* (M5 x 8 )* G * Not included with this unit. [. . . ] · Be sure to ground this unit to the car's chassis again after installation. Notes: · Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC IN-CAR ENTERTAINMENT dealer. · It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 to 8 ). If the maximum power is less than 50 W, change "AMP. GAIN" setting to prevent the speakers from being damaged (see page 38 of the INSTRUCTIONS). · To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape. · The heat sink becomes very hot after use. Be careful not to touch it when removing this unit. . · 50 ( , 4 8 ). 50 , "AMP. GAIN" , (. . Heat sink A Typical Connections / : . . Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit. The leads of the power cord and those of the connector from the car body may be different in color. 1 2 3 Connect the colored leads of the power cord in the order specified in the illustration below. Finally connect the wiring harness to the unit. 1 2 3 . . Note: If your vehicle does not have any accessory terminal, move the fuse from the fuse position 1 (initial position) to fuse position 2, and connect the red lead (A7) to the positive (+) battery terminal. · The yellow lead (A4) is not used in this case. : , 1 ( ) 2 (7) (+) . · (4) . 2 Rear ground terminal Line out (see diagram (. [. . . ] , . Rear speakers Remote lead Y-connector (not supplied with this unit) Y ( ) L R INPUT L R JVC Amplifier JVC- *3 Remote lead (Blue with white stripe) ( ) LINE OUT L R Signal cord (not supplied with this unit) ( ) L KD-G807 R To the remote lead of other equipment or power aerial if any REAR FRONT Front speakers INPUT L R L R JVC Amplifier JVC- Front speakers *3 You can connect another power amplifier for front speakers. . *3 Firmly attach the ground wire to the metallic body or to the chassis of the car--to the place not *3 coated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do -- , ( , so may cause damage to the unit. . CD changer and DAB tuner / - - DAB Refer also to page 42 of the INSTRUCTIONS. [. . . ]