User manual JVC KD-R482

[. . . ] Indd 1 Data Size: Book Size: B6L (182 mm x 128 mm) B6L (182 mm x 128 mm) 7/29/2016 5:10:37 PM Information on Disposal of Old Electrical and Electronic Equipment and Batteries (applicable for countries that have adopted separate waste collection systems) Products and batteries with the symbol (crossed-out wheeled bin) cannot be disposed as household waste. Old electrical and electronic equipment and batteries should be recycled at a facility capable of handling these items and their waste byproducts. Contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on our health and the environment. [. . . ] € The settings made may affect the current settings of [PRO EQ]. 2 Adjust the sound elements of the selected sound tone. • The settings are stored to [USER]. € The settings made may affect the current settings of [EASY EQ]. (or) Press , then turn the volume knob within 5 seconds. Preset equalizer: FLAT (default), DRVN 3, DRVN 2, DRVN 1, HARD ROCK, HIP HOP, JAZZ, POP, R&B, TALK, USER, VOCAL BOOST, BASS BOOST, CLASSICAL, DANCE EASY EQ PRO EQ Store your own sound settings 1 Press and hold to enter EASY EQ setting. 2 Turn the volume knob to select an item, then press the knob. Refer to [EASY EQ] for setting and the result is stored to [USER]. € To return to the previous setting item, press . 2 Turn the volume knob to select an item (see the following table), then press the knob. ( 10) 3 Repeat step 2 until the desired item is selected/activated or 4 Press follow the instructions stated on the selected item. To return to the previous setting item, press . W LEVEL*4 LEVEL 01/LEVEL 02: Boosts low or high frequencies to produce a wellbalanced sound at low volume. W +03): Adjusts the output level of the subwoofer connected via speaker lead. W 00): Adjusts the output level of the subwoofer connected to the lineout terminals (REAR/SW) through an external amplifier. EXPANDER ON: Creates realistic sound by compensating the high-frequency components and restoring the rise-time of the waveform that are lost in (Digital Track audio data compression. Expander) SPK/PRE OUT Depending on the speaker connection method, select the appropriate setting to get the desired output. (  Speaker output settings) PRE-OUT*6 Speaker output settings Select the output setting for the speakers [SPK/PRE OUT], base on the speaker connection method. SUBWOOFER LPF*4 FRQ THROUGH: All signals are sent to the subwoofer ; FRQ 55HZ/FRQ 85HZ/FRQ 120HZ: Audio signals with frequencies lower than 55 Hz/85 Hz/120 Hz are sent to the subwoofer. W PHASE*4 REVERSE (180°)/NORMAL (0°): Selects the phase of the subwoofer output to be in line with the speaker output for optimum performance. (Selectable only if a setting other than [FRQ THROUGH] is selected for [SUBWOOFER LPF]. LEVEL –15 to LEVEL +06 (LEVEL 00): Preset the initial volume level of each source (compared to the FM volume level). [. . . ] ( 12) Turn off the power saving mode on the Android device. Basic procedure 1 Remove the key from the ignition switch, then disconnect the [ terminal of the car battery. See Installing the unit (in-dash mounting). ( 15) 4 Connect the terminal of the car battery. [. . . ]