User manual JVC KD-S1501EU

[. . . ] : When number button 2 works as MO (monaural) button. To use these buttons for original functions again after pressing MODE, wait for 5 seconds without pressing any of these buttons until the functions mode is cleared. To turn off the power You cannot select "CD" as the playback source if there is no disc in the loading slot. Discs produce very little noise compared with other sources. [. . . ] You can store six favorite programme types. 2 Select the preset number (1 ­ 6) you (This occurs when you are listening to an FM station without the RDS signals required for TA Standby Reception. ) To activate TA Standby Reception, tune in to another station providing these signals. PTY Standby Reception allows the receiver to switch temporarily to your favorite PTY programme from any source other than AM. To activate PTY Standby Reception, tune in to another station providing these signals. When driving in an area where FM reception is not sufficient enough, this receiver automatically tunes in to another FM RDS station of the same network, possibly broadcasting the same programme with stronger signals (see the illustration below). When shipped from the factory, NetworkTracking Reception is activated. All tracks will be played repeatedly until you change the source or eject the disc. Total playing time of Total track number the inserted disc of the inserted disc To the beginning of the current track, then the previous tracks. Elapsed playing time Current track number You can lock a disc in the loading slot. You can use only one of the following playback modes at a time. New discs may have some rough spots around the inner and outer edges. If such a disc is used, this receiver may reject the disc. To remove these rough spots, rub the edges with a pencil or ball-point pen, etc. Moisture may condense on the lens inside the CD player in the following cases: · If it becomes very humid inside the car. Should this occur, the CD player may malfunction. In this case, eject the disc and leave the receiver turned on for a few hours until the moisture evaporates. When removing a disc from Center holder its case, press down the center holder of the case and lift the disc out, holding it by the edges. When storing a disc into its case, gently insert the disc around the center holder (with the printed surface facing up). ⷠMake sure to store discs into the cases after use. Do not use the following discs: More about this receiver Turning off the power ⷠIf you turn off the power while listening to a disc, disc play will start from where playback has been stopped previously, next time you turn on the power. This receiver can play back multi-session discs; however, unclosed sessions will be skipped while playing. [. . . ] If the ejected disc is not removed within 15 seconds, the disc is automatically inserted again into the loading slot to prevent it from dust. When a disc is inserted upside down, the disc automatically ejects. If you change the "AMP GAIN" setting from "HIGH PWR" to "LOW PWR" while the volume level is set higher than "VOL 30, " the receiver automatically changes the volume level to "VOL 30. What appears to be trouble is not always serious. [. . . ]