User manual JVC KD-S7

[. . . ] CD RECEIVER CD-RECEIVER RECEPTEUR CD CD-RECEIVER KD-S70R/S7R KD-S70R KD-S7R COMPACT For installation and connections, refer to the separate manual. Für den Einbau und die Anschlüsse siehe das eigenständige Handbuch. Pour l'installation et les raccordements, se référer au manuel séparé. Bijzonderheden over de installatie en aansluiting van het apparaat vindt u in de desbetreffende handleiding. DIGITAL AUDIO INSTRUCTIONS BEDIENUNGSANLEITUNG MANUEL D'INSTRUCTIONS GEBRUIKSAANWIJZING GET0042-001A [E] NEDERLANDS FRANÇAIS DEUTSCH ENGLISH Position And Reproduction Of Labels ENGLISH Bottom panel of the main unit DANGER: Invisible laser radiation when open and interlock failedordefeated. [. . . ] · If the code already stored in memory is selected, it will flash on the display. 4 Press and hold the number button for more than 2 seconds to store the PTY code selected into the preset number you want. The selected code name will flash on the display. 5 SEL Finish the setting. 13 ENGLISH To store your favorite programme types ENGLISH To search your favorite programme type 2 1 1 PTY Press and hold PTY for more than 1 second while listening to an FM station. The last selected PTY code appears. 2 Select one of PTY codes stored in preset number buttons (1 to 6). Ex. When "ROCK M" is stored in preset number button 2. PTY search for your favorite programme starts after 5 seconds. · If there is a station broadcasting a programme of the same PTY code you have selected, that station is tuned in. · If there is no station broadcasting a programme of the same PTY code you have selected, the station will not change. Note: In some areas, the PTY search will not work correctly. 14 Other convenient RDS functions and adjustments Automatic selection of the station when using the number buttons Usually when you press the number button, the preset station is tuned in. However, when the preset station is an RDS station, something different will happen. If the signals from that preset station are not sufficient for good reception, this unit, using the AF data, tunes in another frequency broadcasting the same programme as the original preset station is broadcasting. In case no other station is tuned in, you can also search all receivable frequencies for the same programme. (Programme search) To activate programme search, follow the procedure below. · Programme search takes a while. · See also "Changing the general settings" on page 29. Press and hold SEL (select) for more than 2 seconds to call up the general setting mode. ¢ or 4 to select "P(programme)-SEARCH. " 2. Press the + button and set to "ON". To cancel programme search, repeat the same procedure and select "OFF" in step 3 by turning the control dial counterclockwise. Changing the display mode while listening to an FM station You can change the initial indication on the display to station name (PS NAME), station frequency (FREQ), or clock time (CLOCK) while listening to an FM RDS station. · See also "Changing the general settings" on page 29. Press and hold SEL (select) for more than 2 seconds to call up the general setting mode. ¢ or 4 to select "DISPMODE (display mode). " 2. Press + or ­ to set to the desired indication -- PS NAME (station name), FREQ (station frequency), or CLOCK (clock time). Note: By pressing DISP, you can also change the display while listening to an FM RDS station. Each time you press the button, the following information appears on the display: PS NAME (Station name) CLOCK (Clock time) FREQ (Station frequency) PTY (Programme type) * Then, the display goes back to the original indication in several seconds. Setting the TA volume level You can preset the volume level for TA Standby Reception. [. . . ] This does not damage the unit and the CD, but will be annoying. We recommend that you stop CD play while driving on such rough roads. 33 ENGLISH Handling CDs TROUBLESHOOTING ENGLISH What appears to be trouble is not always serious. Check the following points before calling a service center. Symptoms · CD cannot be played back. [. . . ]