User manual JVC KD-S707R

[. . . ] CD-RECEIVER RECEPTEUR CD CD-RECEIVER KD-SX838R/S737R/S707R KD-SX838R ATT BAND PROG DISC FUNC DISC PRESET 0 /ATT 40 W x 4 MO RND TP/RDS PTY SOUND 11 12 Detachable ¢ SEL 4 7 8 SSM RPT DISP CD CHANGER CONTROL 10 9 BAND CD-CH TUNER CD 5 KD-S737R 0 /ATT KS-S737R 40 W x 4 ¢ SEL 4 7 8 9 10 11 12 SSM MO RND TP/RDS PTY SOUND RPT DISP AM FM CD 5 KD-S707R 0 /ATT KS-S707R 35 W x 4 ¢ SEL 4 7 8 9 10 11 12 SSM MO RND TP/RDS PTY SOUND RPT DISP AM FM CD 5 For installation and connections, refer to the separate manual. Für den Einbau und die Anschlüsse siehe das eigenständige Handbuch. Pour l'installation et les raccordements, se référer au manuel séparé. Bijzonderheden over de installatie en aansluiting van het apparaat vindt u in de desbetreffende handleiding. INSTRUCTIONS BEDIENUNGSANLEITUNG MANUEL D'INSTRUCTIONS GEBRUIKSAANWIJZING VNN3832-311S [E] NEDERLANDS KS-SX838R FRANÇAIS DEUTSCH CD RECEIVER ENGLISH Position And Reproduction Of Labels Bottom panel of the main unit DANGER: Invisible laser radiation when open and interlock failed or defeated. [. . . ] When you wish to reactivate this mode, repeat the same procedure and in Step 3 press the "+" Level Control button to set to "ADJ ON. " In the activated mode, clock time is automatically renewed when the CT data is received. Note: It takes at least 2 minutes to renew the time after receiving CT data. The station must be received for more than 2 minutes continuously, otherwise the clock time will NOT be renewed. 15 ENGLISH Display Mode Setting the main display mode. Press the SEL button for more than 2 seconds to set the preferred setting mode. Select "DISPMODE" with the ¢ or 4 button. Select the desired mode with the + or button. (Station name (PS NAME) Ô Frequency being received (FREQ) Ô Clock time (CLOCK) Ô) (See page 25. ) Note: When the "CLOCK" mode is set, clock time remains on the main display even during playback. Display Button The DISP button is used to select the Operation (Tuner or CD) and Clock modes. Each time the button is pressed, the display changes as follows: Operation mode (Station name* = Frequency being received = PTY; or CD) = Clock time. The display returns to the initially preset mode after a short while. * When the RDS or PTY signal is weak or when not tuned to an RDS or PTY station, the Station name or PTY is NOT displayed. Other convenient tuner functions MO/RND Selecting FM reception sound When an FM stereo broadcast is hard to receive: Press MO/RND (Mono/Random) while listening to an FM stereo broadcast. The sound you hear becomes monaural but reception will be improved. Lights up when receiving an FM broadcast in stereo. MO ST To restore the stereo effect, press the same button again. 16 CD OPERATIONS ENGLISH Playing a CD 1 1 Insert a disc into the loading slot. The unit turns on, draws a CD and starts playback automatically. · When a CD is inserted upside down, "NO DISC" appears on the display and the CD automatically ejects. Total playing time of the inserted disc Total track number of the inserted disc Elapsed playing time Current track Note on One-Touch Operation: When a CD is already in the loading slot, pressing CD turns on the unit and starts playback automatically. CAUTION on Volume Setting CDs produces very little noise compared with other sources. If the volume level is adjusted for the tuner, for example, the speakers may be damaged by the sudden increase in the output level. Therefore, lower the volume before playing a CD and adjust it as required during playback To stop play and eject the CD Press 0. CD play stops and the CD automatically ejects from the loading slot. If you change the source to AM/FM (or CD changer for KD-SX838R only), the CD play also stops (without ejecting the CD this time). · If the ejected disc is not removed for about 15 seconds , the disc is automatically inserted again into the loading slot to protect it from dust. (CD play will not start this time. ) · You can eject the CD even when the unit is turned off. 17 Locating a track or a particular portion on a CD ¢ 4 Number buttons To fast forward or reverse the track Press and hold ¢ SSM , while playing a CD, to fast forward the track. Press and hold 4 , while playing a CD, to reverse the track. To go to the next track or the previous track Press ¢ briefly, while playing a CD, to go ahead to the beginning of the next track. Each time you press the button consecutively, the beginning of the next track is located and played back. [. . . ] We recommend that you stop CD play while driving on such rough roads. 32 TROUBLESHOOTING Symptoms · CD cannot be played back. · CD sound is sometimes interrupted. Causes CD is inserted upside down. Connections are incorrect. Remedies Insert the CD correctly. [. . . ]