User manual JVC KV-MR9010

[. . . ] The driver must not watch the television or playback pictures while driving. If the driver does it while driving, it may lead to carelessness and cause an accident. Keep the monitor at an appropriate sound level while driving. Driving with the sound at a level that prevents you from hearing sounds outside of and around the vehicle may cause an accident. [. . . ] ­ Bewaar de batterij niet met andere metalen ­ Die Batterie nicht zusammen mit ­ Ne laissez pas la pile avec d'autres ­ Do not leave the battery with other materialen. ­ Steek niet met een tangetje of dergelijk ­ Die Batterie nicht mit Pinzetten oder ­ Ne piquez pas la pile avec des ciseaux ­ Do not poke the battery with tweezers gereedschap in de batterij. ­ Wikkel de batterij met band om en isoleer ­ Die Batterie mit Klebeband umwickeln ­ Enveloppez la pile de ruban isolant ­ Wrap the battery with tape and insulate goed alvorens weg te gooien of langdurig und isolieren, wenn sie entsorgt oder avant de la mettre au rebut ou de la when throwing away or saving it. Make sure there is no obstacle in between. Do not expose the remote sensor to strong light (direct sunlight or artificial lighting). Turns off the power if pressed and held. Calls up the menu, then selects the adjustable menu items. Controllable only if your car receiver which is connected to this monitor is one of the JVC receivers. Before operating the unit, make sure that all external components are correctly connected and installed. When not in use, close the liquid crystal panel and store it into the compartment; however, it may obstruct the visibility through the rearview mirror. Press PUSH-OPEN until the liquid crystal panel is unlocked, then open the liquid crystal panel by both hands. When closing the liquid crystal panel, store it in the screen compartment until it is locked. You can select a monitor position from the four positions. 1 Slide the arm lock lever to RELEASE, then pull down or push up the monitor. 2 Slide the arm lock lever to HOLD, then remove the screen arm to the nearest locking position. When closing the liquid crystal panel, push up the monitor to the highest position. Each time you press the button, the playback source changes. To turn off the power / So prüfen Sie die aktuelle Eingangsquelle / Pour mettre l'appareil hors tension / Uitschakelen van de stroom OFF: Activates the door sensor which turns on the dome lights when a · You can use JVC's optional cordless headphones KS-HP2 to listen to the playback sounds of the external component. Playback sounds are transmitted through IR transmitters to the cordless headphones. You can make your own display adjustments using the menu. Menu selection goes off if other operations are done or no operation is done for about 5 seconds. Adjust this if the picture is too bright or too dark. [. . . ] (Since there is the possibility of water drops getting inside of the unit, do not directly apply cleanser to the surface. What appears to be trouble is not always serious. Check the following points before calling a service center. This is a characteristic of liquid crystal panels and is not a malfunction. [. . . ]